1998 CHRYSLER Breeze, Cirrus & Stratus

Chrysler Cirrus LXi 1998 - BUZZERS, RELAYS & TIMERS

Chrysler Cirrus LXi 1998 BUZZERS, RELAYS & TIMERS

Component	Component Location
ABS Relay Box	Rear of modulator, right cowl panel. See Fig. 2 .
A/C Compressor Clutch Relay	In power distribution center.
Automatic Shut Down Relay	In power distribution center.
Engine Starter Motor Relay	In power distribution center.
Fuel Pump Relay	In power distribution center.
Headlamp Delay Relay	On junction block.
High Speed Radiator Fan Relay	In power distribution center.
Horn Relay	On junction block.
Intermittent Wiper Relay	In power distribution center.
Low Speed Radiator Fan Relay	In power distribution center.
Rear Window Defogger Relay	On junction block.
Transmission Control Relay	In power distribution center.
Wiper High/Low Relay	In power distribution center.

Chrysler Cirrus LXi 1998 - CIRCUIT PROTECTION DEVICES

Chrysler Cirrus LXi 1998 CIRCUIT PROTECTION DEVICES

Component	Component Location
Dedicated Fuses	In power distribution center.
Junction Block	Under left side of dash.
Multi-Purpose Fuses	On junction block, under left side of dash.
Power Distribution Center	On left front inner fender. See Fig. 1 .

Chrysler Cirrus LXi 1998 - CONTROL UNITS

Chrysler Cirrus LXi 1998 CONTROL UNITS

Component	Component Location
Air Bag Control Module	Under floor console, behind transmission selector.
Body Control Module	On junction block, under left side of dash.
Controller Anti-Lock Brake	At right front of engine compartment.
Daytime Running Lamp (DRL) Module	Behind dash, on back of multi- function module.
Fuel Pump Module	In center rear of trunk.
Mode Door Actuator	At left end of HVAC housing.
Powertrain Control Module	Left fender side shield, attached to power distribution center. See Fig. 1 .
Speed Proportional Steering Module	On left side of steering gear. See Fig. 1 .
Sun Roof Control Module	At rear of sun roof.
Transmission Control Module	Left fender side shield, attached to power distribution center. See Fig. 1 .

Chrysler Cirrus LXi 1998 - MOTORS

Chrysler Cirrus LXi 1998 MOTORS

Component	Component Location
ABS Hydraulic Modulator	On right cowl panel. See Fig. 2 .
Idle Air Control Motor (2.0L)	On side of throttle body. See Fig. 3 .
Idle Air Control Motor (2.4L)	On side of throttle body. See Fig. 3 .
Idle Air Control Motor (2.5L)	On side of throttle body. See Fig. 4 .
Radiator Fan Motor Assembly	On rear of radiator.
Vapor Canister Leak Detection Pump	At top of fuel tank, near EVAP canister.
Windshield Washer Pump Motor	At bottom of washer fluid reservoir. See Fig. 2 .
Windshield Wiper Motor	Left side of cowl panel, behind strut tower. See Fig. 1 .

Chrysler Cirrus LXi 1998 - SENDING UNITS & SENSORS

Chrysler Cirrus LXi 1998 SENDING UNITS & SENSORS

Component	Component Location
Battery Temperature Sensor	Left side of radiator closure panel, near battery. See Fig. 1 .
Camshaft Position (CMP) Sensor (2.0L)	At rear of cylinder head, on end of camshaft. See Fig. 3 .
Camshaft Position (CMP) Sensor (2.4L)	At rear of cylinder head, on end of camshaft. See Fig. 3 .
Camshaft Position (CMP) Sensor (2.5L)	Integral to distributor.
Crankshaft Position (CKP) Sensor (2.0L)	On right front side of engine block.
Crankshaft Position (CKP) Sensor (2.4L)	On right front side of engine block.
Crankshaft Position (CKP) Sensor (2.5L)	On rear of transmission, above differential housing.
Engine Coolant Temperature Sensor (2.0L)	Top left front of engine. See Fig. 3 .
Engine Coolant Temperature Sensor (2.4L)	Top left front of engine. See Fig. 3 .
Engine Coolant Temperature Sensor (2.5L)	Rear of engine, next to coolant fill neck. See Fig. 4 .
Evaporator Temperature Sensor	In HVAC housing.
Fuel Level Sensor	Integral to fuel pump module.
Heated Oxygen Sensor (HO2S) (Downstream)	On exhaust pipe, behind catalytic converter.
Heated Oxygen Sensor (HO2S) (Upstream)	On exhaust manifold.
Intake Air Temperature/ Manifold Absolute Pressure Sensor (2.0L)	On intake manifold. See Fig. 3 .
Intake Air Temperature Sensor (2.4L)	On intake manifold.
Intake Air Temperature Sensor (2.5L)	On rear of intake manifold plenum. See Fig. 5 .
Manifold Absolute Pressure (MAP) Sensor (2.4L)	On intake manifold plenum.
Manifold Absolute Pressure (MAP) Sensor (2.5L)	On right front of intake manifold. See Fig. 5 .
Oil Pressure Switch (2.0L)	On left front side of engine block.
Oil Pressure Switch (2.4L)	On left front side of engine block.
Oil Pressure Switch (2.5L)	On left side of engine block, above oil filter.
Output Shaft Speed Sensor (A/T)	On left side of transmission case. See Fig. 6 .
Sun Roof Position Sensor	Above headliner, near sun roof opening.
Throttle Position Sensor (2.0L)	On side of throttle body. See Fig. 3 .
Throttle Position Sensor (2.4L)	On side of throttle body. See Fig. 3 .
Throttle Position Sensor (2.5L)	On side of throttle body. See Fig. 4 .
Turbine Speed Sensor (A/T)	On transmission, left of manual shift lever. See Fig. 6 .
Vehicle Speed Sensor (M/T)	Left rear of transmission.
Wheel Speed Sensor (Front) (2)	Attached to respective steering knuckle boss.
Wheel Speed Sensor (Rear) (2)	Attached to respective brake support plate.

Chrysler Cirrus LXi 1998 - SOLENOIDS & SOLENOID VALVES

Chrysler Cirrus LXi 1998 SOLENOIDS & SOLENOID VALVES

Component	Component Location
Duty Cycle EVAP Purge Solenoid	On left strut tower.
Electronic EGR Transducer Solenoid (2.0L)	At rear of cylinder head. See Fig. 3 .
Electronic EGR Transducer Solenoid (2.4L)	At rear of cylinder head. See Fig. 3 .
Electronic EGR Transducer Solenoid (2.5L)	On left side of engine, at rear of cylinder head. See Fig. 4 .
Transmission Solenoids & Pressure Switches (A/T)	On top left front of transmission. See Fig. 6 .
Vehicle Speed Control Servo	On left strut tower. See Fig. 1 .

Chrysler Cirrus LXi 1998 - SWITCHES

Chrysler Cirrus LXi 1998 SWITCHES

Component	Component Location
A/C Pressure Transducer (2.0L)	On A/C compressor discharge line. See Fig. 3 .
A/C Pressure Transducer (2.4L)	On A/C compressor discharge line. See Fig. 3 .
A/C Pressure Transducer (2.5L)	On A/C compressor discharge line. See Fig. 4 .
Autostick Switch	Integral with gearshift mechanism.
Back-Up Lamp Switch (M/T)	Front of transmission.
Brake Warning Pressure Switch	On master cylinder.
Clutch Pedal Position Switch	Top of clutch pedal, on bracket.
Park Brake Switch	At base of parking brake lever.
Power Steering Pressure Switch	On left side of steering gear. See Fig. 1 .
Seat Belt Switch	In base of left "B" pillar.
Stoplamp Switch	Top of brake pedal.
Transmission Range Switch (A/T)	In transmission, on top of valve body. See Fig. 6 .

Chrysler Cirrus LXi 1998 - MISCELLANEOUS

Chrysler Cirrus LXi 1998 MISCELLANEOUS

Component	Component Location
Blower Motor Resistor Pack	Right side of HVAC housing.
Data Link Connector (DLC)	Left of steering column.
Distributor (2.5L)	On right rear of engine, near air intake. See Fig. 4 .
Ignition Coil (2.5L)	Inside distributor.
Ignition Coil Pack (2.0L)	On top of valve cover. See Fig. 3 .
Ignition Coil Pack (2.4L)	On top of valve cover. See Fig. 3 .
Power Amplifier	Under right front seat.

Chrysler Cirrus LXi 1998 - CONNECTORS

Chrysler Cirrus LXi 1998 CONNECTORS LOCATION

Component	Location
C104 (Light Gray, 10 Pin)	Under power distribution center. See Fig. 1 .
C105 (Black, 10 Pin)	Under power distribution center. See Fig. 1 .
C111 (Black, 10 Pin)	Rear of powertrain control module.
C113 (Light Gray, 10 Pin)	Rear of powertrain control module.
C121 (Green, 8 Pin)	Left kick panel.
C126 (Black, 16 Pin)	Near junction block.
C165 (Black, 4 Pin)	Left side of intake.
C169 (Black, 6 Pin)	Left side of transmission.
C224 (Black, 8 Pin)	Left side of steering column.
C305 (Black, 2 Pin)	Near trunk latch.
C308 (White, 8 Pin)	At left "B" pillar.
C309 (Black, 2 Pin)	Under seat.
C310 (Brown, 16 Pin)	At left "A" pillar.
C311 (Blue, 12 Pin)	At left "A" pillar.
C315 (Brown, 16 Pin)	At right "A" pillar.
C316 (Blue, 12 Pin)	At right "A" pillar.
C318 (White, 8 Pin)	At right "B" pillar.

Chrysler Cirrus LXi 1998 - GROUNDS

Chrysler Cirrus LXi 1998 GROUNDS LOCATION

Component	Location
G100	On left strut tower. See Fig. 1 .
G101	On rear of transmission. See Fig. 6 .
G102	On left strut tower. See Fig. 1 .
G103	On right strut tower. See Fig. 2 .
G104	On left kick panel.
G105	On left rear of engine. See Fig. 4 .
G200	On right dash center support.
G201	At base of gearshift.
G300	Center of trunk opening, below latch.
G301	On left side of firewall.
G302	Center of deck lid.

Chrysler Cirrus LXi 1998 - SPLICES

Chrysler Cirrus LXi 1998 SPLICES LOCATION

Component	Location
S100	In breakout for transmission control module. See Fig. 1 .
S101	On left strut tower. See Fig. 1 .
S102	In power distribution center. See Fig. 1 .
S103	In power distribution center. See Fig. 1 .
S104	In power distribution center. See Fig. 1 .
S105	In power distribution center. See Fig. 1 .
S106	In power distribution center. See Fig. 1 .
S108	Near breakout for powertrain control module connector. See Fig. 1 .
S109	On left strut tower. See Fig. 1 .
S110	In power distribution center. See Fig. 1 .
S111	On right strut tower. See Fig. 2 .
S112	Near right strut tower. See Fig. 2 .
S113 (2.0L)	In breakout for generator feed terminal.
S113 (2.4L)	In breakout for generator feed terminal.
S113 (2.5L)	In generator breakout. See Fig. 4 .
S114 (2.0L)	In fuel injector breakout. See Fig. 3 .
S114 (2.4L)	In fuel injector breakout. See Fig. 3 .
S114 (2.5L)	Between fuel injector No. 2 & No. 3.
S115 (2.0L)	Near breakout for MAP/IAT sensor. See Fig. 3 .
S115 (2.4L)	Near breakout for MAP/IAT sensor. See Fig. 3 .
S115 (2.5L)	Near EGR breakout. See Fig. 4 .
S116 (2.0L)	Near breakout for MAP/IAT sensor.
S116 (2.4L)	Near breakout for MAP/IAT sensor.
S116 (2.5L)	Near breakout for fuel injector No. 6. See Fig. 4 .
S117 (2.0L)	Near breakout for camshaft position sensor. See Fig. 3 .
S117 (2.4L)	Near breakout for camshaft position sensor. See Fig. 3 .
S117 (2.5L)	Near breakout for idle air control motor. See Fig. 4 .
S118 (2.0L)	Near breakout for camshaft position sensor. See Fig. 3 .
S118 (2.4L)	Near breakout for camshaft position sensor. See Fig. 3 .
S118 (2.5L)	Near breakout for engine coolant temperature sensor. See Fig. 4 .
S120	Near breakout for powertrain control module.
S121 (2.5L)	In breakout for powertrain control module.
S123	In fuel rail harness. See Fig. 4 .
S124 (2.0L)	Near breakout for noise suppressor.
S124 (2.4L)	Near breakout for noise suppressor.
S124 (2.5L)	Near breakout for distributor. See Fig. 4 .
S125	Near breakout for turbine speed sensor. See Fig. 6 .
S126	Near breakout for EGR.
S129	Near breakout for stoplamp switch.
S130	Near breakout for powertrain control module connector. See Fig. 1 .
S133	In breakout for ignition coil. See Fig. 3 .
S300	Middle of left "C" pillar.
S301	Near trunk latch.
S302	Between left & right visor lamps.
S303	Between left & right visor lamps.
S400	Near left door speaker
S401	Near right door lock switch.
S402	Near breakout for left door speaker.