AIR CONDITIONING — Lincoln Continental 2000 — SYSTEM WIRING DIAGRAMS

AIR CONDITIONING

Automatic A/C Wiring Diagram (1 of 2) for Lincoln Continental 2000

List of elements for Automatic A/C Wiring Diagram (1 of 2) for Lincoln Continental 2000:

• (14b242 harness, near breakout to shift lock actuator) s201
• (bottom of "a" pillar) g900
• (bottom of "a" pillar) g901
• (not used)
• 87a
• Air bag sliding contact (top of steering column, below steering wheel)
• Amb temp sens input
• Ambient air temperature sensor (on left side of upper radiator support)
• Audio/climate control switch assembly
• Battery
• Battery junction box (in engine compartment, above left wheelwell)
• Blend door 5v+
• Blend door actuator
• Blend door actuator (behind lower right side of dash)
• Blend door pot gnd
• Blend door ref
• Blower motor (behind right side of dash, on a/c-heater plenum)
• Blower motor relay
• Blower motor speed controller (behind right side of dash, on a/c-heater plenum)
• Blower mtr rly gnd
• Blower speed out
• C227
• C229
• C274
• C275
• Central junction box (below left side of dash)
• Computer data lines system
• Driver command rtn
• Electronic automatic temperature control (eatc) module (at center of dash)
• Fan
• Fuse 10a
• Fuse 15a
• Fuse 13 40a
• Ground
• Hot at all times
• Hot in run
• Ignition
• Illum input
• In car temp sens
• In-car temperature sensor (behind top right side of dash, above glove box)
• Interior lights system
• Left side of driver seat)
• Nca
• Ohms
• Rear def relay
• Rear window defrost relay (in rear of trunk on, package tray)
• S228 (14b242 harness, near breakout to 8 pin in-line connector, near left side of glove box)
• S264 (14a005 harness, near breakout to park brake switch)
• Scp bus (+)
• Scp bus (-)
• Sensor ground
• Speed control servo (on left shock tower)
• Speed control switch assembly
• Steering whl ctrl
• Sun load sensor (on top of dash, above glove box)
• Sunload sens input
• Temp
• W/o steering wheel controls
• W/steering wheel controls

Automatic A/C Wiring Diagram (2 of 2) for Lincoln Continental 2000

List of elements for Automatic A/C Wiring Diagram (2 of 2) for Lincoln Continental 2000:

• (12a581 harness, near breakout to differential pressure feedback egr (dpfe) sensor)
• (not used)
• (top front of left fender apron) g100
• 87a
• A/c clutch cycling pressure switch (in right front of engine compartment, on a/c accumulator)
• A/c clutch diode
• A/c clutch relay
• A/c compressor clutch coil (lower right front of engine, part of a/c compressor assembly)
• A/c pressure transducer (in right front of engine compartment, on a/c line)
• Battery junction box (in engine compartment, above left wheelwell)
• Digital transmission range (dtr) sensor (on left side of engine on top of transaxle)
• Dual auxiliary relay box (center of engine compartment, on upper radiator support)
• Engine cooling fan (behind radiator)
• Fuse 30a
• Fuse 60a
• G100 (top front of left fender apron)
• High speed cooling fan relay
• Hot at all times
• Low speed cooling fan relay
• Pcm power relay
• Powertrain control module (pcm) (on top right side of firewall, under splash shield)
• Red
• S122 (12a581 harness, near breakout to radio interference capacitor)
• S124
• S153 (14290 harness near breakout to anti-theft hood switch)
• S155 (14290 harness, near breakout to anti-theft hood switch)
• S156 (14290 harness, near breakout to 4 pin in-line connector, left rear of engine compartment, near brake fluid reservoir)
• Tan/ red