AIR CONDITIONING – Subaru Legacy GT 2004 – SYSTEM WIRING DIAGRAMS

AIR CONDITIONING

Manual A/C Wiring Diagram for Subaru Legacy GT 2004

List of elements for Manual A/C Wiring Diagram for Subaru Legacy GT 2004:

• (at left front of engine compt)
• (behind right side
• (on right side of upper intake unit case) fresh/recirc actuator
• (right front of engine compt) sub fan motor
• A/c pressure switch (on a/c receiver-drier)
• A/c relay holder
• A/c relay holder (left side of engine compt)
• Air conditioning relay
• B134
• B135
• B136
• B137
• B152
• B52
• B84
• Blower motor (behind right side of dash)
• Blower motor relay (at left kick panel)
• Blower motor resistor (behind right side of dash)
• Combination meter
• Engine control module (behind right side of dash)
• Engine controls system
• Engine coolant temperature sensor & thermometer (right rear of engine)
• Evaporator thermo switch
• F41
• Fuse & relay box (left rear of engine compt)
• Fuse 15a
• Fuse 20a
• Gb-2
• Gb-5 (under front of center console)
• Gb-7 (at front left side of center console)
• Hot at all times
• Hot in on or start
• I12
• I15
• I17
• Interior lights system
• Magnet clutch
• Main fan relay
• Mode actuator (behind center of dash)
• Mode control panel
• Nca
• Of dash, on intake unit case)
• Radiator main fan motor (left front of engine compt)
• Rear defogger relay
• Red
• Shield & sensor ground joint connector (lower right end of dash)
• Sub fan relay
• W/ low emission
• W/o low emission