ANTI-LOCK BRAKES – Buick Century Custom 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Buick Century Custom 2000

List of elements for Anti-lock Brake Wiring Diagrams for Buick Century Custom 2000:

• (2000) (1999)
• (below dash, left of steering column)
• A10
• A11
• A8 b5
• Abs fuse 10a
• Abs maxi fuse 60a
• Abs warning
• B10
• B11
• B12
• B6 a11
• Battery
• Body control module (bcm) (behind left side of dash)
• Brake
• Brake fluid level indicator switch (in brake fluid reservoir)
• Brake pressure modulator valve
• C1 stop lamp switch (brake pedal support bracket)
• C10
• C11
• C2 c2
• C3 c2
• Cluster fuse 10a
• Data link connector (dlc) (under left side of dash)
• Delivered torque
• Desired torque
• Electronic brake control module (ebcm) (at left side of engine compartment)
• Electronic power steering system
• Electronic traction control switch
• Fuse block
• G129 (left of starter, on transaxle stud)
• G202
• G202 (on steering column)
• Ground
• Hot at all times
• Hot in run, bulb test or start
• Ignition
• Instrument cluster
• Interior lights system
• Left front wheel spd (hi)
• Left front wheel spd (lo)
• Left front wheel speed sensor
• Left rear wheel spd (hi)
• Left rear wheel spd (lo)
• Left rear wheel speed sensor
• Low trac
• Nca
• Pnk
• Powertrain control module (pcm) (left front of eng compt)
• Pump motor
• Red
• Right front wheel spd (hi)
• Right front wheel spd (lo)
• Right front wheel speed sensor
• Right rear wheel spd (hi)
• Right rear wheel spd (lo)
• Right rear wheel speed sensor
• S205 (i/p harn, right of steering column)
• S211
• Serial data signal
• Solid state
• Splice pack (sp205) (right side of steering column)
• Stop lamp sw out
• Stop lamps fuse 15a
• Strng var assist motor
• Tan
• Trac off
• Underhood accessory wiring junction block
• Vent tube