ANTI-LOCK BRAKES – Dodge Cab & Chassis R2500 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Dodge Cab & Chassis R2500 2002

List of elements for Anti-lock Brake Wiring Diagrams for Dodge Cab & Chassis R2500 2002:

• (left bottom of dash)
• 4wd ind
• 4wd sensor
• 4wd switch (on front axle)
• A10
• A20
• B113
• B114
• Brake lamp switch (on brake pedal bracket)
• Brake pressure switch (on combination valve)
• Brake sw sense
• Ccd bus (+)
• Ccd bus (-)
• Controller anti-lock brake (left fender side shield)
• Data link connector
• Diesel
• Engine controls system
• Fuse 10a
• Fuse 40a
• Fuse b (+)
• Fuse ign sw (run)
• G100 (left fender side shield)
• G101 (left fender side shield)
• G107
• G200 (left kick panel)
• Ground
• Hot at all times
• Hot in run
• Instrument cluster
• J/c 1 (in pdc)
• Joint connector 7 (left side of dash)
• Junction block (left end of dash)
• Left front wheel speed sensor (w/ all wheel abs) (on left front steering knuckle)
• Lf whl spd sensor (+)
• Lf whl spd sensor (-)
• Power distribution center (in engine compt, on left inner fender panel, near battery)
• Powertrain control module (right rear of eng compt)
• Rear wheel speed sensor (in differential housing)
• Rear whl spd sensor (+)
• Rear whl spd sensor (-)
• Red
• Red brake ind driver
• Rf whl spd sensor (+)
• Rf whl spd sensor (-)
• Right front wheel speed sensor (w/ all wheel abs) (on right front steering knuckle)
• S112
• S113
• S151
• S152 (near left front wheel speed sensor)
• S174 (transmission harness, in breakout to power distribution center)
• V40
• Vehicle speed sen sig
• Vss