ANTI-LOCK BRAKES
Anti-lock Brake Wiring Diagrams for Dodge Dakota 2002
List of elements for Anti-lock Brake Wiring Diagrams for Dodge Dakota 2002:
- (4.7l only)
- (near diagnostic junction port)
- (under dash, left of steering column)
- 4.7l w/ a/t
- A10
- A20
- B113
- B114
- Brake fluid level switch (in brake system combination valve)
- Brake lamp sw sense
- Brake lamp switch (on brake pedal bracket)
- Brake transmission shift interlock solenoid
- Controller anti-lock brake (abs: on top of hydraulic control unit, rwal: in eng compt, on left inner fender panel)
- D25
- Data link connector
- Diagnostic junction port (under dash, right of steering column)
- Fuse 10a
- Fuse 40a
- Fuse ign sw output (run)
- Fused b (+)
- G113 (near battery)
- G207 (lower center of dash)
- Ground
- Hot at all times
- Hot in run
- J/c 2 (in pdc)
- Junction block (on left end of dash)
- Left front sensor (+)
- Left front sensor (-)
- Left front wheel speed sensor (w/ all wheel abs) (on left steering knuckle)
- Pci bus
- Power distribution center (in engine compartment, on left inner fender panel)
- Powertrain control module (in eng compt, on right inner fender panel)
- Powertrain control module (in engine compt, on right inner fender panel)
- Rear wheel sens (+)
- Rear wheel sensor (-)
- Rear wheel speed sensor (on top of differential housing)
- Red
- Right front sensor (+)
- Right front sensor (-)
- Right front wheel speed sensor (w/ all wheel abs) (on right steering knuckle)
- S126
- S174 (near powertrain control module)
- S190 (left rear of eng compt)
- Sci receiver
- Transmission control module (in right front engine compt, on radiator core support)
- V40
- Vehicle speed sig
- W/ all wheel abs
- Warning indicator driver
- Z19