ANTI-LOCK BRAKES – Ford Excursion 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram, Early Production for Ford Excursion 2000

List of elements for Anti-lock Brakes Wiring Diagram, Early Production for Ford Excursion 2000:

• 22k ohm
• 4-wheel anti-lock brake system (4wabs) module (in left front of engine compartment)
• 4wabs ind ctrl
• 4x4 high/low ind
• 5.6k ohm
• Anti-lock brake indicator
• Battery junction box (in left side of engine compt, on top of wheelwell)
• Bpp switch feed
• Brake fluid level sw
• Brake fluid level switch (on brake fluid reservoir)
• Brake pedal position (bpp) switch (behind left side of dash, above brake pedal)
• C104a
• C104b
• C240a
• C242b
• C250a
• C250c
• Central junction box (behind lower left side of dash)
• Computer data lines system
• Data link connector (behind center of dash)
• Diagnostic circuit
• Differential speed sensor (dss) (on center of rear axle)
• Engine controls system (generic electronic module (gem), instrument cluster, central junction box, overhead console module, powertrain control module, speed control servo)
• Fuse 10a
• Fuse 5a
• Fuse 60a
• G100 (left front of engine compt)
• G104 (rear of left front fender)
• G200 (left kick panel)
• Generic electronic module (gem) (behind lower left side of dash)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Ignition feed
• Instrument cluster
• Left front anti-lock brake sensor (at wheel)
• Left front sensor (high)
• Left front sensor (low)
• Nca
• Power (b+)
• Rear sensor (high)
• Rear sensor (low)
• Red/pnk
• Right front anti-lock brake sensor (at wheel)
• Right front sensor (high)
• Right front sensor (low)
• S102
• S108
• S165 (engine harness, left side of engine compt)
• S178 (engine harness, left side of engine compt)
• S201
• S271
• S288
• Tan/red
• Transmissions system
• Vss (+)