ANTI-LOCK BRAKES
All-Wheel ABS Wiring Diagram for Ford Ranger Splash 1997
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for All-Wheel ABS Wiring Diagram for Ford Ranger Splash 1997:
- (4wabs) hydraulic unit (left side of engine compartment)
- (4wabs) indicator ctrl
- (4wabs) main relay (relay box #3: left rear of engine compt.)
- (4wabs) pmp rly coil (-) g-switch #2
- (4wabs) pump motor relay (relay box #3)
- (4wabs) relay coil (-)
- (dash to headlamp harn, in breakout to relay box 3) s129
- (left front of vehicle)
- 1400 ohms
- 4wabs diode
- 4wabs main relay maxi fuse 9 30a
- 4wabs pump motor
- 4wabs pump relay maxi fuse 10 30a
- Acceleration sensor (on inside of left frame rail)
- Anti-lock brakes indicator
- Brake on/off (boo) switch (on brake pedal support)
- Brake on/off sw feed
- C215
- C216
- Connector (dlc) (bottom of i/p, near steering column)
- Data link
- Diagnostic circuit
- Dump valve
- Engine compartment fuse/relay box (left rear of engine compt.)
- Four wheel anti- lock brake system (4wabs) control module (left front of engine compartment)
- Fuse 10a
- Fuse 15a
- Fuse 7.5a
- G-switch #1
- G-switch status
- G104 (top center of left fender apron)
- G108 (left side of upper radiator support)
- Ground
- Hot at all times
- Hot in run
- Hot in run or start
- I/p fuse panel (behind left side of i/p)
- Ignition (hot in run)
- Instrument cluster
- Iso
- Iso valve
- Left front
- Left front dump valve
- Left front iso valve
- Left front sensor (hi)
- Left front sensor (lo)
- Left front wheel speed sensor
- Motor speed sensor (hi)
- Nca
- Pnk
- Rear
- Rear axle sensor
- Rear dump valve
- Rear iso valve
- Rear sensor (high)
- Rear sensor (low)
- Red/pnk
- Right front
- Right front dump valve
- Right front iso valve
- Right front sensor (hi)
- Right front sensor (lo)
- Right front wheel speed sensor
- S118
- S124
- S125
- S132 (dash to headlamp harn, near breakout to starter relay)
- S142
- S148
- S225
- S240
- Tan
- Tan/red
- Valve
- Vehicle ref. voltage
Rear Wheel ABS Wiring Diagram for Ford Ranger Splash 1997
List of elements for Rear Wheel ABS Wiring Diagram for Ford Ranger Splash 1997:
- (main harn, near breakout to i/p fuse panel) s235
- (main harn, near breakout to i/p fuse panel) s236
- 1.2 ohms
- 22k ohms
- 4.0 ohms
- Abs ind
- Acc
- Boo switch input
- Brake fluid level sig
- Brake fluid level switch (left rear of engine compartment, on brake fluid reservoir)
- Brake ind
- Brake on/off (boo) switch (behind left side of i/p, on brake pedal support)
- C141
- C215
- C216
- Daytime running lamps (drl) module (left side of lower radiator support)
- Diag/keep alive input
- Diff speed sens (hi)
- Diff speed sens (lo)
- Dump sol output
- Engine compartment fuse/relay box (left rear of engine compt.)
- Fuse 11 7.5a
- Fuse 13 15a
- Fuse 14 20a
- Fuse 9 10a
- G104 (top center of left fender apron)
- G108 (left side of upper radiator support)
- Gnd
- Ground
- Hot at all times
- Hot in run
- Hot in run or start
- I/p fuse panel (behind left side of i/p)
- Ignition switch
- Instrument cluster
- Iso sol output
- Isolation solenoid
- Lock
- Nca
- Off
- Power input
- Rabs diode
- Rabs ind ctrl
- Rabs resistor
- Rabs test connector (c244) (behind right side of i/p)
- Rabs test connector (on rear of engine compartment fuse/relay box)
- Rear anti-lock brake system (rabs) module (behind lower center of i/p, left side of ashtray assembly)
- Rear anti-lock brake system (rabs) proportioning valve switch assembly (below left side of vehicle, on inside of left frame rail)
- Rear axle sensor (top of rear differential)
- Red
- Red/pnk
- Run
- S118
- S120 (dash to headlamp harn, left side of safety wall)
- S131
- S150 (dash to headlamp harn, in breakout to engine cpmpt fuse/relay box)
- S204
- S205
- S228
- S240
- S244
- Start
- Valve reset input
- Valve reset switch