ANTI-LOCK BRAKES
Anti-lock Brakes Wiring Diagram for Hyundai Elantra GLS 2003
List of elements for Anti-lock Brakes Wiring Diagram for Hyundai Elantra GLS 2003:
- (on frame member, near generator) g17
- (w/ trip)
- (w/o trip)
- Abs active module
- Abs control module (in right front corner of engine compartment)
- Abs indicator
- Abs indicator control
- Abs pump motor
- Abs solenoids
- Connector (dlc) (partial) (below left side of dash)
- Data link
- Diagnosis
- Engine compartment relay & fuse box (in left front corner of engine compartment, behind battery)
- Engine control module (ecm) (behind left side of dash, above kick panel)
- Fuse 10a
- Fuse 15a
- Fusible link (abs 1) 30a
- Fusible link (abs 2) 30a
- Ground
- Hot at all times
- Hot in on or start
- I/p-b
- I/p-h
- I/p-j
- Illum
- Instrument cluster
- Interior lights system
- J/c c91
- J/c m36
- Left front wheel sensor (on left front hub assembly)
- Left rear wheel sensor (on left rear hub assembly)
- M09-3
- M10-1
- M10-2
- Nca
- Note: abs control module contains: abs solenoids, tcs solenoids & abs pump motor
- Passenger compartment junction block (under left side of dash, near kick panel)
- Pnk
- Red
- Right front wheel sensor (on right front hub assembly)
- Right rear wheel sensor (on right rear hub assembly)
- Solid state
- Start/on input
- Stop lamp switch signal
- Stoplamp switch (on brake pedal bracket)
- Tcs indicator
- Tcs indicator control
- Tcs switch
- Tcs switch on
- Vehicle speed signal
- W/ cruise control
- W/ trip
- W/o cruise control
- W/o trip
- Wheel speed input