ANTI-LOCK BRAKES
Anti-lock Brake Wiring Diagrams for Hyundai XG300 2001
List of elements for Anti-lock Brake Wiring Diagrams for Hyundai XG300 2001:
- Abs bleeding connector (front of eng compartment)
- Abs control module (at right rear side of engine compartment, on strut tower)
- Abs fuse 10a
- Abs fusible link 1 30a
- Abs fusible link 2 30a
- Abs indicator
- Abs pump motor
- Abs solenoids
- Abs/ebd warn ind ctrl
- Brake warning indicator
- C44-3
- Can (high voltage)
- Can (low voltage)
- Data link connector (dlc) (partial) (under dash, to right of steering column)
- Diagnosis
- Ecu check input
- Engine compartment junction block (at left front corner of engine compartment)
- Engine controls system
- Front right speed sens out
- Fuse 10a
- G105 (rear of right front fender)
- Ground
- Hot at all times
- Hot at on or start
- Hot in on or start
- I18-2
- I18-3
- Illum
- Indicator control circuit
- Instrument cluster
- Interior lights system
- Jc01
- Ji01
- Jm02
- Jm04
- Left front wheel sensor
- Left rear wheel sensor
- Nca
- Note: abs control module contains: abs solenoids & abs pump motor
- Off
- Passenger compartment junction block (behind left side of dash)
- Pcm (behind lower center of dash)
- Pnk
- Red
- Right front wheel sensor
- Right rear wheel sensor
- Solid state
- Start/on input
- Stop lamp sw input
- Stoplight switch (on brake pedal bracket)
- Tan
- Tcs indicator
- Tcs switch (if equipped)
- Tcs warn & tcs off ind ctrl
- W/cruise control
- W/o cruise control
- Wheel speed input