ANTI-THEFT
Anti-theft Wiring Diagram for Chevrolet Corvette 1998
List of elements for Anti-theft Wiring Diagram for Chevrolet Corvette 1998:
- (not used)
- A nca
- A/t
- Accy
- B nca
- B10
- Body control module (mounted on toe board)
- Bulb test
- C14
- Clutch pedal switch (top of clutch pedal)
- Crk fuse 14 10a
- D16
- Driver dr ajar
- Exterior lights system (backup lights circuit)
- Exterior lights system (drl relays)
- F/tnkdr fuse 32 15a
- F12
- Fog lamp switch/ rear compartment lid release switch
- G200
- G203
- Ground
- Horn rly
- Horns system (horn relay)
- Hot at all times
- Ignition key
- Ignition key lock cylinder
- Ignition switch
- Instrument panel electrical center (right front footwell)
- Key in
- Key out
- Key sw in
- Left door ajar indicator switch
- Left door control module (bottom of left door)
- Left door key switch
- Lock
- Lt drl rly
- M/t
- Off
- Park/neutral position switch (left side of transmission)
- Pass dr ajar
- Pass key rtn
- Pass-key in
- Per/mlp rly
- Powertrain control module (right side of engine compt)
- Red
- Resistor pellet
- Right door ajar indicator switch
- Right door control module (bottom of right door)
- Right door key switch
- Rr compt rel
- Rt door ajar
- Rt drl rly
- Run
- S210 (i/p harn, right of blower motor control module breakout)
- Serial data
- Splice pack 201 (left kick panel)
- Splice pack 202 (right kick panel)
- Star connector 1 (in instrument panel harness)
- Start
- Starter enable
- Starter maxifuse 60a
- Starting/ charging system (starter)
- Tan
- Theft deterrent relay (in right front footwell)