ANTI-THEFT
Anti-theft Wiring Diagram for Mercury Cougar XR7 1996
List of elements for Anti-theft Wiring Diagram for Mercury Cougar XR7 1996:
- 0.162k
- 20a
- Acc fuse 10a
- Alarm ind
- Anti-theft controller module (left side of trunk, behind wheel well)
- Anti-theft ignition sensor (in steering column, at ignition switch)
- Anti-theft in-line fuse holder (left front of trunk, above wheel well)
- Both doors lock out
- C226
- C232
- C251
- C408
- C409
- C455
- C457
- Door ajar in
- Door ajar out
- Door disarm in
- Door lock actuators
- Door open in
- Driver door unlock out
- Driver's door unlock
- Exterior lights system
- G200
- G203 ground bus (behind right cowl panel, near front door sill)
- Gnd
- Ground bus (behind left cowl panel, near front door sill)
- Headlights system
- Horn out
- Horns system (horn relay)
- Hot at all times
- Hot in acc or run
- Ignition tamper sens
- Instrument cluster
- Instrument cluster system (indicator lamp module)
- Int lps fuse 10a
- Left door ajar switch (top rear of left door)
- Left door anti-theft disarm switch (top of left door, part of door lock cylinder)
- Lo beam out
- Nca
- Parking lmp out
- Passenger door unlock out
- Primary junction block
- Pwr (acc/run)
- Pwr (hat)
- Red
- Remote/keyless entry module (left side of trunk, above wheel well, behind trim)
- Right door ajar switch (top rear of right door)
- Right door anti-theft disarm switch (top of right door, part of door lock cylinder)
- Seat/lock circuit breaker 20a
- Starter interrupt
- Starting/ charging system
- Trunk lid in
- Trunk lock tamper switch (center of trunk lid, near cylinder lock assembly)
- Unlocks door in