COOLING FAN
Cooling Fan Wiring Diagram for Hyundai Santa Fe GLS 2006
List of elements for Cooling Fan Wiring Diagram for Hyundai Santa Fe GLS 2006:
- 2.7l
- 3.5l
- C121-a
- C121-b
- C121-c
- C23-f
- C23-m
- Condenser fan motor (at front of engine compt, on right side of radiator support)
- Condenser fan relay 1
- Condenser fan relay 2
- E/r-b
- E/r-c
- E/r-e
- E/r-h
- Ecm/pcm (below center of dash)
- Ect sensor
- Engine compartment junction block (on left side of engine compt)
- Engine controls system
- Engine coolant temperature sensor & sender (2.7l: on rear of left cylinder head) (3.5l: at rear of engine)
- Fan relay ctrl (high)
- Fan relay ctrl (low)
- Fuse 10a
- Fusible link (c/ fan) 20a
- Fusible link (rad fan) 40a
- G05 (at left front of engine compt, on inner fender panel)
- G06 (at right front of engine compt, near power steering fluid reservoir)
- Hot at all times
- Hot in on or start
- I/p-b
- Joint connector c134 (under center console)
- Nca
- Passenger compartment junction block (behind lower left end of dash)
- Pnk
- Radiator fan motor (at front of engine compt, on left side of radiator support)
- Radiator fan relay
- Sensor ground