CRUISE CONTROL – Chevrolet Equinox LT 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Equinox LT 2005

List of elements for Cruise Control Wiring Diagram for Chevrolet Equinox LT 2005:

• brake/cruise release sw sig
• (behind steering wheel) inflatable restraint steering wheel module coil
• 5 volt ref a
• 5 volt ref b
• 8.25k
• A12
• Accelerator pedal position (app) sensor (on accelerator pedal linkage arm)
• All times
• App sens 1 sig
• App sens 2 sig
• App sensor 1
• App sensor 2
• Automatic transmission
• Body control module (bcm) (center of dash behind hvac control module)
• Brake fuse 15a
• C2 b8
• C276
• C277
• Class 2 (ecm)
• Class 2 serial data
• Computer data lines system
• Cruise control on ind
• Cruise fuse 2a
• Cruise/brake switch (on brake pedal bracket)
• G201 (behind lower left side of dash, left of steering column)
• Hot at
• Hot in acc or run
• Ign
• Instrument panel cluster (ipc)
• Left steering wheel controls
• Logic
• Low ref
• Oss high
• Oss low
• Pnk
• Powertrain control module (top of battery cover)
• R/a 4.42k
• Right steering wheel controls
• S/c 1.5k
• S233
• Serial data bus+
• Serial data bus-
• Service engine soon (mil) indicator
• Service vehicle soon indicator
• Set/coast resume/ accelerate signal
• Stop lamp sig switch
• Stop lamp sw sig
• Stop lamp switch (on brake pedal bracket)
• Tan
• Throttle actuator control (tac) module (attached to throttle body)
• Touch controls
• Transmission control module (tcm) (left side of engine compt)
• Uart serial data 1
• Uart serial data 2
• Underhood fuse block (left side of engine compt)
• Vehicle speed sensor (oss)
• W/o touch controls