CRUISE CONTROL – Chevrolet Impala LS 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Impala LS 2004

List of elements for Cruise Control Wiring Diagram for Chevrolet Impala LS 2004:

• A/c cruise fuse 10a
• Anti-lock brakes system
• B11
• Body control module (bcm) (behind left side of dash, above parking brake lever)
• Brake sig input
• Brk sw fuse 15a
• C11
• Computer data lines system
• Cruise control module (ccm) (on left strut tower)
• Cruise control on/off switch
• Cruise control release switch (behind left side of dash, on brake pedal support)
• Cruise fuse 2a
• Cruise ind
• Cruise inhibit
• Cruise on/off
• Cruise release sig
• Cruise set/coast
• Disable output
• Engage output
• Engaged input
• Exterior lights system
• G113 (on transaxle stud, near starter)
• Ground
• Hot at all times
• Hot in run
• Ignition
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Left i/p junction block (left side of dash, behind access panel)
• Left steering wheel controls
• Logic
• Nca
• Power distribution system
• Powertrain control module (pcm) (in air cleaner box)
• Resume/ accel switch
• Resume/accel
• Right i/p junction block (right side of dash, behind access panel)
• Right steering wheel controls
• S106
• S217 (i/p wiring harness, 7.5 cm from bcm breakout)
• Serial data
• Set/ coast switch
• Stoplamp switch (on brake pedal support)
• Turn signal/ multifunction switch (in steering column)
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (on right rear of engine compt, end of transaxle)
• Vss high
• Vss low