CRUISE CONTROL – Chevrolet Impala LS 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LS 2009

List of elements for Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LS 2009:

• (except 5.3l: above starter motor) (5.3l: below starter motor) g111
• 5 volt ref
• 5 volt ref 1
• 5 volt ref 2
• 5.3l
• Body control module (bcm) (left side of dash)
• Brake pedal position sensor (left side of dash)
• Computer data lines system
• Cruise ctrl ind sig
• Cruise ctrl sw sig
• Cruise ind
• Ecm ign fuse 10a
• Engine control module (ecm) (inside air cleaner assembly)
• Except 5.3l
• Gnd
• Hot w/ ign main pcb relay energized
• Ign
• Ign 1 voltage
• Inflatable restraint steering wheel module coil (under steering wheel)
• Instrument panel cluster (ipc)
• Logic
• Low ref
• Nca
• Pnk
• Sens 1 sig
• Sens 2 sig
• Serial data
• Serial data +
• Serial data -
• Sply voltage
• Steering ctrl sig
• Stop lamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tp sensor 1 sig
• Tp sensor 2 sig
• Underhood fuse block (right side of engine compt)
• Vehicle speed sig
• X275
• X277

Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LS 2009

List of elements for Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LS 2009:

• (top of engine) throttle body
• 5.3l
• Accelerator pedal position (app) sensor (left side of dash)
• Cruise on ind
• Except 5.3l
• Front sig high
• Front sig low
• J213 (steering wheel harness, behind inflatable restraint steering wheel module)
• Left steering wheel control switch
• On/off cancel
• Res+
• Right steering wheel control switch
• Set-
• Tan
• Transmission control module (tcm) (left side of engine compt)
• Vehicle speed sensor (vss) assembly (right side of transaxle)
• Vehicle speed sig
• W/ steering wheel accessory control
• W/o steering wheel accessory control