CRUISE CONTROL – Chevrolet SSR 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet SSR 2005

List of elements for Cruise Control Wiring Diagram for Chevrolet SSR 2005:

• (left rear of engine compt)
• Accelerator pedal position sensor (above accelerator pedal assembly)
• App sens 1
• App sens 2
• B10
• Close
• Computer data lines system
• Cruise indicator
• Cruise on
• Ecm fuse 34 15a
• Electronic brake control module (ebcm) (left side of inner frame rail)
• Engine control module (ecm) (left front side of engine compt)
• Exterior lights system
• G101 (lower left front of engine)
• G103
• Ground
• Hot at all times
• Hot in run
• Hot in run & start
• Hvac i fuse 39 10a
• Ign 1 volt
• Ign e fuse 23 10a
• Ignition
• Instrument panel cluster (ipc)
• Logic
• Low ref
• On/off switch
• Open
• Pnk
• R/a input
• Rear fuse block (rear center of passenger compartment)
• Ref low
• Res/accel switch
• S/c input
• S101
• S116 (a/t)
• S2025
• S203
• S204 (a/t)
• Serial data
• Set/coast switch
• Speed sig
• Stop fuse 34 15a
• Stop- lamp switch (top of brake pedal bracket)
• Stop/lp fuse 13 25a
• Stp lp in
• Tac cntrl
• Tac ctrl
• Tan
• Tcc brk sw
• Throttle body
• Tp sens 1
• Tp sens 2
• Turn signal/ multifunction switch
• Underhood fuse block (on left side of engine compt)
• Vehicle speed sensor (on right rear of transmission)
• Vss high sig
• Vss low sig