CRUISE CONTROL – Chevrolet Tracker 2000 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Tracker 2000

List of elements for Cruise Control Wiring Diagram for Chevrolet Tracker 2000:

• (behind left side of dash)
• 1.6l & 2.0l
• 10k
• 2.5l (2001)
• 230 ohm
• 910 ohm
• A/t
• Brake signal
• Cancel
• Cancel signal
• Clutch control release switch
• Cruise control mode switch
• Cruise control servo (left front of engine compt, near strut tower)
• Cruise ind
• Engine control system
• Engine controls system
• Fi fuse 15a
• Fuse block (right side of engine compt in front of battery)
• G112 (left front of engine compt)
• G131 (on intake manifold)
• G202
• Ground
• Hot at all times
• Hot in run & start
• Ig fuse 20a
• Ignition
• Indicator control
• Instrument cluster
• Instrument cluster, transmission systems
• Interior lights system
• Interrupt signal
• Junction block (in left kick panel)
• M/t
• Main cruise control switch
• Main relay (beside junction block)
• Main relay control
• Mode ground
• Mode signal
• O/d cut
• O/d cut signal
• Powertrain control module (under right side of dash)
• Res/acc
• S102
• S103
• S104
• S108
• S200
• S202
• S212
• S213
• S214
• S215
• S216
• S219
• S241
• S250
• Set/coast
• Sp200
• Starter solenoid (right rear side of engine)
• Stop fuse 15a
• Stoplamp switch (above brake pedal)
• T/p signal
• Tp input
• Transmission range switch (front right side of transmission)
• Vehicle speed sensor (vss) (right side of transmission)
• Vss input
• Wiper/washer switch