CRUISE CONTROL
Cruise Control Wiring Diagram for Chevrolet Tracker 2002
List of elements for Cruise Control Wiring Diagram for Chevrolet Tracker 2002:
- (behind left side of dash)
- 1.6l & 2.0l
- 10k
- 2.5l
- 230 ohm
- 910 ohm
- A/t
- Brake signal
- Cancel
- Cancel signal
- Clutch control release switch
- Cruise control mode switch
- Cruise control servo (left front of engine compt, near strut tower)
- Cruise ind
- Engine control system
- Engine controls system
- Fi fuse 15a
- Fuse block (right side of engine compt in front of battery)
- G103 (on intake manifold)
- G104 (left front shock tower, near horn)
- G200
- Ground
- Hot at all times
- Hot in run & start
- Ig fuse 20a
- Ignition
- Indicator control
- Instrument cluster
- Instrument cluster system
- Interior lights system
- Interrupt signal
- Junction block (in left kick panel)
- M/t
- Main cruise control switch
- Main relay (beside junction block)
- Main relay control
- Mode ground
- Mode signal
- O/d cut
- O/d cut signal
- Powertrain control module (under right side of dash)
- Res/acc
- S102 (engine harness)
- S103 (engine harness)
- S104 (engine harness)
- S108
- S200
- S202
- S212 (main harness)
- S213 (main harness)
- S214 (main harness)
- S215 (main harness)
- S216 (main harness)
- S219
- S241
- S250
- Set/coast
- Sp200
- Starter solenoid (right rear side of engine)
- Stop fuse 15a
- Stoplamp switch (above brake pedal)
- T/p signal
- Tp input
- Transmission range switch (front right side of transmission)
- Vehicle speed sensor (vss) (right side of transmission)
- Vss input
- Wiper/washer switch