CRUISE CONTROL – Chrysler PT Cruiser 2002 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chrysler PT Cruiser 2002

List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser 2002:

• on/off
• (below steering column)
• (center rear of dash) g200
• (cruise)
• (left side of engine)
• (near breakout to engine oil pressure switch)
• (near datalink connector)
• (under left side of dash) datalink connector
• +8v
• A/t
• Brake lamp switch
• Cancel
• Clock- spring
• Computer data lines system
• Cruise
• Dump
• Fuse 10 10a
• Fuse block (lower left front of dash)
• Fused ignition
• G104 (front of right front fender)
• Ground
• Hot in run or start
• Instrument cluster
• M/t
• Pci bus
• Pnk
• Powertrain control module (on firewall, behind power distribution center)
• Red/ tan
• Res/accel
• S107
• S109
• S121
• S126
• S139 (near breakout to left foglamp)
• S201
• S239
• Sci receive
• Sci transmit
• Sensor gnd
• Set/coast
• Speed control servo (right rear of engine compt)
• Speed signal
• Speed sw sig
• Tan/red
• Transmission control module (left front of engine compt)
• Vacuum
• Vacuum sol
• Vehicle speed control switch
• Vehicle speed sensor (m/t) (right rear side of transaxle)
• Vent
• Vent sol
• Vf display
• Vss input