CRUISE CONTROL – Chrysler Sebring Touring 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chrysler Sebring Touring 2004

List of elements for Cruise Control Wiring Diagram for Chrysler Sebring Touring 2004:

• (2.4l)
• (a/t)
• (under horn pad) s218
• 2.4l
• 2.7l
• A/t
• Body control module (at left kick panel)
• Brake lamp switch (at top of brake pedal assembly)
• Brake sw
• Brake switch sense
• Brake transmission shift interlock solenoid (a/t) (behind left side of dash)
• Cancel
• Clockspring
• Coast
• Compass/ mini-trip computer
• Controller anti-lock brake (at lower left front of engine compt)
• Cruise control lamp control
• Cruise engaged lamp
• D25
• Diagnostic
• Dump
• Fuse 7 20a
• Fused b(+)
• G103 (near left front strut tower)
• G203 (behind left side of dash)
• G204 (behind left side of dash, on steering column harness)
• Hot at all times
• Instrument cluster
• Junction block (left end of dash)
• K29
• Left speed control switch
• M/t
• On/off
• Pci bus
• Pci bus (pcm)
• Powertrain control module (left front of engine compt)
• Resume/ accel
• Right speed control switch
• S120 (at left kick panel)
• S219 (under horn pad)
• S225 (premium)
• Set
• Speed sig
• Speed sw sig
• Tan/red
• Transmission control module (left front of engine compartment)
• V32
• V35
• V36
• V37
• Vacuum
• Vacuum sol
• Vehicle speed control servo (on left strut tower)
• Vehicle speed sensor signal
• Vent
• Vent sol