CRUISE CONTROL
Cruise Control Wiring Diagram for Dodge Durango 2003
List of elements for Cruise Control Wiring Diagram for Dodge Durango 2003:
- (4.7l)
- (4.7l: right rear of engine, 5.9l: near a/c low pressure switch breakout)
- (5.9l)
- (behind right side of dash)
- 4.7l
- 5.9l
- Accel/ resume
- Brake lamp switch (on brake pedal bracket)
- Cancl
- Clockspring
- Coast
- Cruise indicator
- Cruise indicator control
- D25
- Data link connector (under dash, left of steering column)
- Dump
- Fuse 10a
- Fused ign
- G112 (right front fender side shield)
- Hot in run or start
- Instrument cluster
- Joint connector 3 (in power distribution center)
- Junction block (left end of dash)
- Left speed control switch
- Nca
- On/off
- Pci bus
- Powertrain control module (right front inner fender, forward of washer fluid reservoir)
- Right speed control switch
- S101
- S201 (behind center of dash)
- S202
- Sensor gnd
- Set
- Speed sw sig
- V32
- V35
- V36
- V37
- Vacuum
- Vacuum sol
- Vehicle speed control servo (right front fender)
- Vent
- Vent sol