CRUISE CONTROL
Cruise Control Wiring Diagram for Ford Bronco 1995
List of elements for Cruise Control Wiring Diagram for Ford Bronco 1995:
- (behind left side of instrument panel, taped to main harness near steering column)
- (behind left side of instrument panel)
- (in steering wheel)
- (left front corner of engine compartment)
- (left front of engine compartment, on upper radiator support)
- (left side of engine compartment, near brake master cylinder)
- (left side of safety wall)
- (on brake pedal support)
- (on brake/ clutch
- 15a
- 4wabs control module
- A/t
- Accel
- Brake on/off (boo) switch
- Brake on/off sw in
- Brake on/off sw input
- Brake press input
- Brake pressure switch (opens when brake
- Brush
- Clutch pedal position switch
- Clutch pedal position switch jumper
- Coast
- Engine compartment fuse box
- Fuse 13
- Fuse e 15a
- Fuse panel
- G108
- G203 (behind bottom of right cowl panel)
- Ground
- Ground stop lamp sw feed
- Horn
- Horns, anti-theft &
- Hot at all times
- Hot in run
- Instrument cluster
- Keyless entry
- M/t
- Nca
- Off
- Ohms
- Pedal support)
- Powertrain control module (pcm)
- Programmable speedometer/ odometer module (psom)
- Red
- Red/
- Resume
- Set/
- Speed cont sw gnd
- Speed cont sw in
- Speed control servo/ amplifier assembly
- Speed control/ horn switch assembly
- System has pressure) (near left front rail)
- Systems
- Tan/
- Vehicle power
- Vehicle speed (vss) input
- Vehicle speed input
- Vehicle speed output
- Vss input vss input
- Vss output
- W/ e4od or 4r70w transmission only