CRUISE CONTROL – Ford Bronco 1996 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Bronco 1996

List of elements for Cruise Control Wiring Diagram for Ford Bronco 1996:

• (behind bottom of right cowl panel)
• (behind left side of instrument panel, taped to main harness near steering column)
• (behind left side of instrument panel)
• (left side of engine compartment, near brake master cylinder)
• (left side of safety wall)
• (not used)
• (on brake pedal support)
• (on brake/ clutch
• 15a
• 4wabs control module (left front corner of engine compartment)
• A/t
• Accel
• Brake on/off (boo) switch
• Brake on/off in
• Brake press in
• Brake pressure switch (near left front frame rail) (opens when brake system is pressurized)
• Brush
• Clutch pedal position switch
• Clutch pedal position switch jumper
• Coast
• Engine compartment fuse box
• Fuse 13
• Fuse 5 15a
• Fuse panel
• G108 (left upper radiator support)
• G203
• Ground
• Horn
• Horns, anti- theft & door locks system
• Hot at all times
• Hot in run
• Instrument cluster
• M/t
• Nca
• Off
• Ohms
• Pedal support)
• Power
• Powertrain control module (pcm)
• Programmable speedometer/ odometer module (psom)
• Red
• Red/
• Resume
• Set/
• Spd ctrl sw rtrn
• Speed control servo/ amplifier assembly
• Speed control/ horn switch assembly (in steering wheel)
• Speed ctrl sw in
• Vehicle speed (vss) input
• Vss input
• Vss output