CRUISE CONTROL – Ford Explorer 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Explorer 1997

List of elements for Cruise Control Wiring Diagram for Ford Explorer 1997:

• A/t w/ high series console
• A/t w/o high series console
• Accel
• Back light
• Brake on/off (boo) switch (on brake pedal support)
• Brake press input
• Brake pressure switch (left rear corner of engine compt)
• C286
• C338
• Clutch pedal position (cpp) switch (on clutch pedal arm)
• Clutch pedal position (cpp) switch jumper (left side of i/p, taped to main harness)
• Coast
• Fuse 15a
• Fuse 7.5a
• G100 (left front of engine compt, near radiator)
• G104 (left rear corner of engine compartment, at fender apron)
• Ground
• Headlamp switch
• Horn relay (in power distri- bution box)
• Horn switches
• Hot at all times
• Hot in run
• Ignition
• Ignition cylinder tamper switch
• Indicator control
• Instrument cluster
• Interior fuse panel
• Interior lights system
• M/t
• Maxi fuse 11 20a
• Nca
• Off
• Ohms
• Power distribution box
• Remote anti-theft personality (rap) module (left rear quarter panel)
• Resume
• S113
• S134
• S156
• S157
• S168 (engine harn, near breakout to 4wabs control module)
• S212 (main harn, near breakout to data link conn)
• Set/
• Speed cont sw gnd
• Speed cont sw in
• Speed control indicator lamp
• Speed control servo/ amplifier assembly (right rear of engine compartment)
• Speed control/ horn switch assembly (in steering column assembly)
• Vehicle speed input
• Vehicle speed sensor (vss) (on transmission)