CRUISE CONTROL – Ford Explorer 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Explorer 2001

List of elements for Cruise Control Wiring Diagram for Ford Explorer 2001:

• (w/ aux controls)
• (w/o aux controls)
• 4-wheel anti-lock brake system (4wabs) module (in left side of engine compt)
• A/t w/ high series console
• A/t w/o high series console
• Accel
• Air bag sliding contact (in steering column)
• Back light
• Battery junction box
• Brake pedal position (bpp) switch (behind steering column)
• Brake press input
• Brake pressure switch (left rear corner of engine compt)
• C186
• C286
• C338
• Clutch pedal position (cpp) switch (on clutch pedal arm)
• Clutch pedal position (cpp) switch jumper (left side of dash, taped to main harness)
• Coast
• Fuse 10 15a
• Fuse 20a
• Fuse 7.5a
• Fuse junction panel
• G104 (rear of left front fender)
• G105 (rear of right front fender)
• G108 (left radiator support)
• Ground
• Horn relay (behind right side of dash, in rpo relay block)
• Horn switches
• Hot at all times
• Hot in run
• Ignition
• Indicator control
• Instrument cluster
• Interior lights system
• M/t
• Main light switch
• Nca
• Off
• Ohms
• Pnk
• Rear axle sensor (on axle assembly)
• Red/
• Remote anti-theft personality (rap) module (behind left side of dash)
• Resume
• S161
• S168 (near breakout to 4wabs control module)
• S215 (near breakout to ignition switch)
• S230
• S232
• S244
• Set/
• Speed cont sw gnd
• Speed cont sw in
• Speed control indicator lamp
• Speed control servo (in right rear of engine compartment)
• Vehicle speed input