CRUISE CONTROL – GMC Canyon 2011 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Canyon 2011

List of elements for Cruise Control Wiring Diagram for GMC Canyon 2011:

• (above brake pedal assembly) stop lamp switch
• (body harness, 14.5 cm from accelerator pedal position switch breakout) j100
• (not used)
• 5-volt reference
• A/t
• A11
• Accelerator pedal position (app) sensor (on accelerator bracket)
• Anti-lock brakes system
• App sensor 1 signal
• App sensor 2 signal
• Class 2 serial data
• Clstr fuse 10a
• Clutch pedal pos sig
• Clutch pedal position (cpp) sensor (m/t)
• Coast
• Computer data lines system
• Cruise
• Cruise control release signal
• Cruise control release switch (above brake pedal assembly)
• Cruise control switch
• Cruise control switch signal
• Cruise fuse 10a
• Cruise indicator
• Engine control module (ecm) (right rear of engine compt)
• Exterior lights system
• G105
• Hot at all times
• Hot in run or start
• Instrument panel cluster (ipc)
• J331 (w/ dvd)
• Jx105 (left side of engine compt)
• Logic
• Low reference
• M/t
• Pnk
• Power distribution system
• Resume/ accel
• Run/crank relay
• Serial data +
• Serial data -
• Set/
• Stop fuse 20a
• Stop lamp control
• Switch
• Tac motor control-1
• Tac motor control-2
• Tan
• Throttle body (on intake, near map sensor)
• Tp sensor 1 signal
• Tp sensor 2 signal
• Transmission control module
• Turn signal/multi-function switch
• Underhood fuse block (left front side of engine compt)
• Vehicle speed sensor (vss) (2wd: left rear of transmission) (4wd: on left rear of transfer case)
• Vses stop relay
• Vss high sig
• Vss high signal
• Vss low sig
• Vss low signal
• X104
• X125
• X200
• X204