CRUISE CONTROL – GMC Terrain Denali 2014 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Terrain Denali 2014

List of elements for Cruise Control Wiring Diagram for GMC Terrain Denali 2014:

• (right kick panel) g207
• (steering
• 12-volt ref
• 2.4l x1
• 5 volt ref
• 5-volt 2 ref
• 5-volt 4 ref
• 5-volt ref
• Accelerator pedal position sensor (top of accelerator pedal assembly)
• App sen 1 sig
• App sen 2 sig
• Automatic transmission assembly
• B+ volt
• Body control module (lower left side of dash)
• Brake pedal position sensor (top of brake pedal assembly)
• Cancel
• Computer data lines system
• Control module x4)
• Control solenoid valve assembly
• Cruise ctrl sw sig
• Cruise ind
• Cruise switch
• Cruise/etc/tcc brk sig
• Data bus(+)
• Data bus(-)
• Ecm batt fuse 10a
• Engine control module (left front of engine compt)
• G112 (2.4l: lower left front of engine) (3.6l: left rear of engine)
• G210 (left side of dash)
• Gnd
• Hi sig
• Hot at all times
• Hot w/ ignition main relay energized
• Ign 1 volt
• Instrument cluster
• Instrument panel fuse block (right center of dash)
• Interior lights system
• Ipc ign fuse 5a
• J103
• J205
• J207 (body harness, 50 cm from k9 body
• Led backlight dimming control
• Left steering wheel controls switch
• Lo sig
• Logic
• Low ref
• Low ref 1
• Pnk
• Reset+
• Right steering wheel controls switch
• Rvc batt snsr fuse 5a
• Sens sig
• Ser data
• Serial data bus +
• Serial data bus -
• Set-
• Steering wheel air bag coil
• Str whl dm fuse 2a
• Tac close
• Tac open
• Tan
• Tan c
• Tcm batt fuse 15a
• Throttle body (2.4l: left side of engine) (3.6l: top right front of engine)
• Tp sensor 1 sig
• Transmission control module
• Transmission input shaft speed sensor
• Transmission output shaft speed sensor
• Underhood fuse block (left rear of engine compt)
• Wheel)
• X1 3.6l
• X112
• X206