CRUISE CONTROL – Honda CR-V EX 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Honda CR-V EX 2004

List of elements for Cruise Control Wiring Diagram for Honda CR-V EX 2004:

• "on" indicator
• (at left side of engine) g101
• (at left side of engine) g101
• (at rear of engine) junction connector c103
• (not used) k9
• (under left side of dash) g501
• A/t
• A/t communi- cation
• A15
• A18
• Actuator ctrl
• Brake pedal positon switch (behind dash, on brake pedal support)
• Brake switch input
• Cable reel
• Cancel switch
• Clutch pedal position switch (on clutch pedal support)
• Cruise control actuator (on right rear of engine compt)
• Cruise control indicator light
• Cruise control main switch
• Cruise control set/ resume/ cancel switch
• Cruise control signal input
• Cruise control switch light
• Cruise control unit (below left side of dash)
• D10
• D12
• E25
• Ecm (behind right side of dash)
• Fuse 10 7.5a
• Fuse 4 10a
• Fuse 7 15a
• G201 (behind right side of front bumper)
• G501 (under left side of dash)
• Gauge assembly
• Ground
• Horn relay
• Horn sw
• Horn switch
• Hot at all times
• Hot in on or start
• Ign input
• Indicator light control
• Inhibitor input
• Interior lights system
• M/t
• Main on
• Motor close
• Motor open
• Multiplex control unit
• O11
• O12
• Off
• Pcm (behind right side of dash)
• Pnk
• Red
• Resume/ sw input
• Resume/ switch
• Security control unit connector (optional)
• Set switch
• Set/sw input
• Speed sensor input
• Steering wheel
• Transmission range switch (on lower rear of transaxle)
• Underdash fuse/relay box (behind left side of dash, right of steering column)
• Underhood fuse/relay box (on left side of engine compt)
• Vehicle speed output
• Vss (on top left of transaxle)