CRUISE CONTROL
Cruise Control Wiring Diagram for Hyundai Elantra 1998
List of elements for Cruise Control Wiring Diagram for Hyundai Elantra 1998:
- (gl)
- (gl) (gls)
- (gls)
- (wagon) g404 (left rear side of trunk)
- A/t shift lever
- Automatic transaxle
- C01
- Control valve
- Cruise clutch pedal position switch (near clutch pedal bracket)
- Cruise control actuator (right rear corner of engine compt)
- Cruise control module (in center of dash, under radio)
- Cruise control switch
- Cruise ctl ind
- Cruise ind
- Cruise on in
- Cruise on ind
- Cruise switch
- Dash fuse box (under left side of dash, at kick panel)
- Data link connector (on left side of dash)
- Diode z03 (taped inside main wire harness, lower left side of dash)
- Dlc
- E59-1
- E59-2
- Engine control module (ecm) (behind dash, left of steering column)
- Exterior lights system
- Fuse 10 10a
- Fuse 15 10a
- Fuse 16 10a
- Fuse 3 15a
- G200 (left kick panel)
- G206 (center of dash)
- G904 (sedan) (left c- pillar)
- Ground
- Hot at all times
- Hot in on
- Hot in on or start
- I-03
- I04-1 i01-1
- I04-3 i01-1
- Instrument cluster
- Interior lights system
- Manual transaxle
- Multifunction switch
- N d
- Nca
- O/d off ind
- O/d on in
- Off
- Overdrive switch
- Power
- Prk/neutral in (a/t) cltch postion in (m/t)
- Red
- Release valve
- Resume/ accel
- Resume/accel
- Set/ coast
- Set/coast in
- Starting/ charging system
- Stop lamp sw
- Stop lamp switch
- Transaxle control module (tcm) (on left rear corner of engine compt)
- Transaxle range switch (on left side of transaxle)
- Vacuum motor
- Vehicle spd in