CRUISE CONTROL
Cruise Control Wiring Diagram for Hyundai Elantra GLS 2000
List of elements for Cruise Control Wiring Diagram for Hyundai Elantra GLS 2000:
- (dash panel) g206
- (front of left front fender) g100
- (left kick panel) g200
- (on brake pedal bracket) stoplight switch
- (on left side of dash)
- A/t
- A/t shift lever
- Acc
- Control valve
- Cruise
- Cruise clutch pedal position switch (closed w/clutch pedal depressed) (near clutch pedal bracket)
- Cruise control actuator (right rear corner of engine compartment)
- Cruise control module (in center of dash, under radio)
- Cruise control switch
- Cruise ctrl ind
- Cruise on input
- Cruise switch
- Dash fuse box (under left side of dash, at kick panel)
- Data link connector (dlc) (partial)
- Diagnosis
- Diode z03 (under dash, right of steering column)
- E59-2
- Engine compartment relay & fuse box (in right front corner of engine compartment, behind battery)
- Engine control module (ecm) (behind dash, left of steering column)
- Fuse 10 10a
- Fuse 16 10a
- Fuse 3 15a
- G203 (right kick panel)
- Gls
- Ground
- Hot at all times
- Hot at on
- Hot at on or start
- Ignition switch
- Ill
- Ind
- Instrument cluster
- Interior lights system
- Io1-1
- Io1-2
- Io1-3
- Io4-1
- Io4-2
- Io4-3
- Lock
- M/t
- Multifunction switch
- N d
- Nca
- O/d off
- O/d on input
- O/d on output
- Off
- On input
- Over drive switch
- P/n position input (a/t) clutch pedal position input (m/t)
- Red
- Reed switch (input to speedometer)
- Release valve
- Resume/ accel
- Resume/accel in
- Set/ coast
- Set/coast in
- Start
- Start relay
- Stop lamp sw
- Transaxle control module (tcm) (on left rear corner of engine compartment)
- Transaxle range (tr) switch (on left side of transaxle)
- Vacuum motor
- Vehicle speed in
- Vss input