CRUISE CONTROL
Cruise Control Wiring Diagram for Hyundai Santa Fe 2004
List of elements for Cruise Control Wiring Diagram for Hyundai Santa Fe 2004:
- (2.4l w/ a/t)
- (2.4l w/ m/t)
- (3.5l)
- (above brake pedal, on bracket) stop lamp switch
- (at left front of engine compt) joint connector c33 c133
- (behind lower left end of dash) j/c m05
- (or red)
- 3.5l
- A/t
- Acc
- Actuator clutch
- C121-c
- C133
- C21
- C21-c
- C22-d
- C24-1
- C33
- Cancel
- Clock spring
- Clutch pedal position switch (above clutch pedal, on bracket)
- Connector (behind lower left end of dash)
- Cruise control module (on right side of engine compartment)
- Cruise ind
- Cruise on/off
- Cruise remote control switch
- Cruise sw ind on
- Data link
- E/r-d
- E/r-e
- E/r-g
- Ecu 3 fuse 10a
- Engine compartment junction block (on left side of engine compartment)
- Etacm
- Except 3.5l
- Fuse 14 10a
- Fuse 19 10a
- Fuse 25 10a
- Fuse 4 10a
- G03 (2.4l) g02 (2.7l) g103 (3.5l) (2.4l, 2.7l: under center console, near srs control module) (3.5l: under center console)
- G06 (at right front of engine compartment, near power steering fluid reservoir)
- G07 (behind left front kick panel)
- Ground
- Hall ic
- Hot at all times
- Hot in on
- Hot in on or start
- Hot with engine control relay energized
- I/p-b
- I/p-j
- I/p-l
- I/p-m
- Ignition switch
- Instrument cluster
- J/c m06 (behind lower left end of dash)
- Left side
- Lock
- M/t
- M13-3
- M15-5
- M15-6
- Multi- function switch
- Nca
- O/d control
- Off
- Park/neutral input
- Passenger compartment junction block (behind lower left end of dash)
- Pcm/ecm (below center of dash)
- Pnk
- Power source
- Powertrain control module (2.4l)
- Red
- Remote ground
- Resume/ accel
- Right side
- Set/ coast
- Start
- Starting/ charging
- Steering wheel
- Stoplamp sw input
- Sw input
- System
- Tcm (2.7l) (below center of dash)
- Vehicle speed input
- Vehicle speed sensor (on right side of transaxle)