CRUISE CONTROL
Cruise Control Wiring Diagram for Hyundai Sonata GLS 1998
List of elements for Cruise Control Wiring Diagram for Hyundai Sonata GLS 1998:
- (2.0l)
- (3.0l)
- A/t
- A/t shift lever
- Brake switch
- Control valve
- Cruise clutch pedal position switch (below left side of dash, on clutch pedal support)
- Cruise control actuator (on right rear of engine compt, near strut tower)
- Cruise control module (behind center of dash)
- Cruise control switch
- Cruise ctl ind
- Cruise ind
- Cruise on ind
- Cruise switch
- Dash fuse box (under left side of dash, at kick panel)
- Data link connector (on left side
- Diagnosis
- Diode z01
- Engine controls system
- Exterior lights system
- Fuse 2 15a
- Fuse 20 10a
- Fuse 22 10a
- Fuse 8 10a
- G202 (upper left side of dash)
- G206 (below center of dash)
- Ground
- Hot at all times
- Hot in on
- Hot in on or start
- I16-2
- I16-3
- Instrument cluster
- Instrument cluster system
- Interior lights system
- Lower center of dash, above accelerator pedal) m31-1
- M/t
- Multifunction switch
- N d
- Nca
- O/d on input
- Off
- Overdrive switch
- Power
- Prk/neutrl in
- Release valve
- Resume/ accel
- Resume/accel
- Set/ coast
- Set/coast
- Shift interlock system
- Speed sensor
- Starting/ charging system
- Stop lamp sw
- Stop lamp switch
- Tcm
- Transaxle control module (behind center of dash)
- Transaxle range switch (on lower right side of engine compt, on top of transaxle)
- Transmissions system
- Vacuum motor