CRUISE CONTROL – Hyundai Tiburon 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Hyundai Tiburon 1997

List of elements for Cruise Control Wiring Diagram for Hyundai Tiburon 1997:

• (w/ eps)
• (w/o eps)
• A/t shift lever
• Automatic transaxle
• C01
• Control valve
• Cruise clutch pedal position switch
• Cruise control actuator (top rear center of engine)
• Cruise control module (below center of dash, in front of console)
• Cruise control switch
• Cruise ctl ind
• Cruise ind
• Cruise on in
• Cruise on ind
• Cruise switch
• Dash fuse box (left kick panel)
• Data link connector (left side of dash)
• Diagnosis
• Diode z09
• Driver seat belt switch
• E59-1
• E59-2
• Engine control module (ecm) (left side of dash)
• Engine controls system
• Exterior lights system
• Fuse 10 10a
• Fuse 15 10a
• Fuse 16 10a
• Fuse 3 15a
• G200 (left kick panel)
• G904 (left "c" pillar)
• Ground
• Hot at all times
• Hot in on
• Hot in on or start
• Ignition switch
• Instrument cluster
• Interior lights system
• Joint connector (left kick panel)
• M-06
• Manual transaxle
• Multifunction switch
• N d
• Nca
• O/d off ind
• O/d on in
• Off
• Overdrive switch
• Power
• Prk/neutral in (a/t) cltch postion in (m/t)
• Red
• Release valve
• Resume/ accel
• Resume/accel
• Set/ coast
• Set/coast in
• Starting/charging system
• Stop lamp sw
• Stop lamp switch
• Transaxle control module (tcm) (left side of dash)
• Transaxle range switch (on top of transaxle)
• Vacuum motor
• Vehicle spd in