CRUISE CONTROL
4.2L
4.2L, Cruise Control Wiring Diagram for Isuzu Ascender LS 2008
List of elements for 4.2L, Cruise Control Wiring Diagram for Isuzu Ascender LS 2008:
- 5 volt ref
- Accelerator pedal position (app) sensor
- App sensor 1
- App sensor 2
- B10
- B4 x1
- C9 x2
- Close
- Cruise ind
- Cruise release
- E3 x3
- Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
- Engine control module (near lower left front of engine)
- Exterior lights system
- G108 (on lower left side of engine)
- Gnd
- Hot at all times
- Hot in run
- Hot in run or start
- Hvac i fuse 39 10a
- Ign
- Ign e fuse 22 10a
- Instrument panel cluster (ipc)
- Ipc class 2 serial data
- J101
- J105
- J239
- Logic
- Low ref
- Nca
- On sw
- On/off switch
- Open
- Pnk
- Power distribution system
- Rear fuse block (below left rear seat)
- Res+
- Res/accel sw
- Serial data
- Serial data bus +
- Serial data bus -
- Set-
- Set/coast sw
- Splice pack jx205 (behind left of dash, near headlamp switch connector)
- Stop lamp fuse 12 25a
- Stop lamp in
- Stop lamp switch (on brake pedal assembly)
- Tac motor ctrl 1
- Tac motor ctrl 2
- Tan
- Throttle body (front of intake duct)
- Tp sensor 1
- Tp sensor 2
- Transmission control module (tcm) (left front of engine compt)
- Turn signal/ multi-function switch
- Underhood fuse block (above left front wheelwell)
- Veh stop fuse 34 15a
- Vehicle speed sensor (vss) (inside automatic transmission assembly)
- Vss hi
- Vss lo