CRUISE CONTROL – Isuzu Ascender S 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Isuzu Ascender S 2007

List of elements for Cruise Control Wiring Diagram for Isuzu Ascender S 2007:

• 5 volt ref
• Accelerator pedal position (app) sensor (above accelerator pedal, on bracket)
• App sensor 1
• App sensor 2
• B10
• B4 c1
• C9 c2
• Close
• Cruise ind
• Cruise release
• E3 c3
• Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
• Exterior lights system
• Hot at all times
• Hot in run
• Hot in run or start
• Hvac i fuse 39 10a
• Ign
• Ign e fuse 22 10a
• Instrument panel cluster (ipc)
• Ipc class 2 serial data
• Logic
• Low ref
• On sw
• On/off switch
• Open
• Pnk
• Power distribution system
• Powertrain control module (on upper left side of engine)
• Rear fuse block (below left rear seat)
• Res/accel sw
• Res/accel switch
• S239
• Serial data
• Set/coast sw
• Set/coast switch
• Splice pack sp205 (behind left of dash, near headlamp switch connector)
• Stop lamp fuse 12 25a
• Stop lamp switch (on brake pedal assembly)
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle body (front of intake duct)
• Tp sensor 1
• Tp sensor 2
• Turn signal/ multifunction switch
• Underhood fuse block (above left front wheelwell)
• Veh stop fuse 34 15a
• Vehicle speed sensor (vss) (on left rear of transfer case)
• Vss hi
• Vss lo