CRUISE CONTROL
Cruise Control Wiring Diagram for Isuzu Axiom 2002
List of elements for Cruise Control Wiring Diagram for Isuzu Axiom 2002:
- (left side of engine)
- A/t mode switch (left side of trans)
- Acceleration position sensor assembly (above accelerator pedal)
- Acceleration sensors
- Anti-lock brakes system
- Ap sen1 gnd
- Ap sen2 gnd
- Ap sensor 1
- Ap sensor 2
- Ap sensor 3
- Aps3 gnd
- Brake sw in
- Brake switch (on brake pedal support)
- C-11 meter fuse 15a
- C-12 engine fuse 15a
- C-14 back-up/ turn light fuse 15a
- C-26 (left side of engine compt)
- C-6 stop light fuse 15a
- Cancel
- Cruise brake
- Cruise control main switch
- Cruise control res/acc switch
- Cruise lmp
- Cruise set light
- Cruise sw
- Dash fuse box (on left of dash, behind trim panel)
- Drive input
- E-21
- E-21 (left side of engine)
- E-23 (right side of engine)
- E-34
- E-35
- Eb-15 pcm fuse 30a
- Fuse/ relay box (right side of engine compt)
- Gnd
- Hot at all times
- Hot in on or start
- I-22
- Ign feed
- Illum
- Interior lights
- Meter assembly
- On ind
- On switch
- Pcm main relay (in fuse/ relay box)
- Powertrain control module (pcm) (left side of engine compartment)
- Red
- Ref volt
- Res/acc in
- Set/cst
- Th val mtr
- Throttle position sensor 1
- Throttle position sensor 2
- Throttle val
- Throttle valve assembly (on throttle body assembly)
- Throttle valve motor
- Tps 1 sign
- Tps1 gnd
- Tps2 gnd
- Tps2 sign
- Transmission systems
- Vehicle speed sensor (right side of trans) (2wd) (rear of transfer case) (4wd)
- Vss in