CRUISE CONTROL – Mercury Tracer LS 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mercury Tracer LS 1997

List of elements for Cruise Control Wiring Diagram for Mercury Tracer LS 1997:

• (dash to head- lamp harn, near breakout to in- line conn, below center of dash) s242
• (dash to headlamp harn, near breakout to i/p fuse panel)
• (engine harn, near breakout to power- train control module)
• (steering column harn, in breakout to steering column)
• A/t
• Asc fuse 10a
• Brake on/off (boo) switch (on brake pedal support)
• Brake pres- sure switch (behind left side of i/p)
• C210
• C240
• C269
• Clutch pedal position switch (top of clutch pedal support)
• Coast
• G112 (near starter motor)
• Hot at all times
• Hot in start or run
• I/p fuse panel
• M/t
• Nca
• Off
• Ohms
• Resume
• S206
• S209
• S232
• S233
• S244
• S247
• Set/ accel
• Slip ring assembly (top of steering column)
• Speed control amplifier (right front side of engine)
• Speed control switch assembly (in steering wheel)
• Stop fuse 15a
• Vehicle speed sensor (vss) (rear of trans)