CRUISE CONTROL – Mitsubishi Montero 1999 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mitsubishi Montero 1999

List of elements for Cruise Control Wiring Diagram for Mitsubishi Montero 1999:

• (1998-99)
• (a/t)
• (behind left side of dash)
• (not used)
• (on bracket, above brake pedal)
• 1998-99
• A/t
• Auto cruise control ecu
• C06
• C12
• C149
• C150
• C38
• C80
• C81
• C93
• C94
• C97
• Cancel
• Clock spring
• Clutch pedal position switch (on clutch pedal bracket)
• Combination meter
• Combination meter (vss)
• Cruise control actuator (in left rear of engine compt)
• Cruise control main switch
• Cruise control switch
• Cruise indicator
• Data link connector (behind left side of dash, near relay box)
• Dedicated fuse 5 10a
• Engine compartment relay box (on left inner fender behind battery)
• Engine control module (behind right kick panel)
• Exterior lights system
• G100 (front of left front fender)
• G200 (left kick panel)
• G206 (center of dash)
• Hot at all times
• Hot in acc
• Hot in park or head
• Hot in run
• Idle
• Ignition switch pin 5 (start)
• Illumination
• Interior lights system (rheostat)
• Iod or iod or storage storage connector connector (in engine (in engine compt compt relay box) relay box)
• J/c 1 (behind left side of dash)
• J/c 2 (behind left side of dash)
• J/c 3 (behind left side of dash)
• Junction block
• M/t
• Multi- purpose fuse 11 10a
• Multi- purpose fuse 17 15a
• Multi- purpose fuse 19 10a
• Multi- purpose fuse 2 10a
• Multi- purpose fuse 4 10a
• Off
• On indicator
• Or run
• Or start
• Overdrive switch
• Red
• Resume
• Set
• Stop- light switch
• Throttle position sensor (on throttle body)
• Transmissions system