CRUISE CONTROL – Nissan Quest GXE 2000 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Quest GXE 2000

List of elements for Cruise Control Wiring Diagram for Nissan Quest GXE 2000:

• (in fuse & fusible link box) j/c 4
• Air valve
• Ascd actuator (right side of engine compt)
• Ascd brake switch (on bracket, above brake pedal)
• Ascd control unit (right side of driver's footwell)
• Ascd hold relay (on relay box, left front corner of engine compartment)
• Ascd main switch
• Ascd steering switch
• Brake nc sw
• Brake no sw
• Cancel
• Combination meter
• Cruise ind
• Cruise lamp
• Cruise switch
• Fuse & fusible link box (left front of engine compt)
• Fuse 22 20a
• Fuse 29 10a
• Fuse 42 15a
• Fuse block (behind dash, left of steering column)
• G100 (front of left front fender)
• G201 (right side of dash)
• G206 (center rear of dash)
• Ground
• Horn relay (on relay box)
• Horns system
• Hot at all times
• Hot in on or start
• Illum- ination
• Interior lights system
• J/c 4 (in fuse & fusible link box)
• Main switch
• Od cancel
• Od cut signal
• Off
• Park/neutral position relay (on relay box)
• Pnk
• Pump power
• Release valve
• Res/acc sw
• Resume/ accelerate
• Set/coast
• Set/coast sw
• Speed- ometer
• Spiral cable
• Starting/ charging system
• Stoplight switch (on bracket, above brake pedal)
• Transmission control module (tcm) (behind dash, right of steering column)
• Vacuum motor
• Vacuum valve
• Vehicle speed sensor (on transaxle)
• Vss