CRUISE CONTROL – Nissan Sentra CA 2000 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Sentra CA 2000

List of elements for Cruise Control Wiring Diagram for Nissan Sentra CA 2000:

• 11k
• 4th cut sw
• Accel/ res switch
• Ascd brake switch (w/a/t) (on brake pedal bracket)
• Ascd clutch switch (w/m/t) (on clutch pedal bracket)
• Ascd control unit (behind left side of dash)
• Ascd motor actuator (left rear of engine compt)
• Ascd steering switch
• Brake nc sw
• Brake no sw
• Cancel switch
• Clutch
• Combination meter
• Command sw
• Cruise
• Cruise lamp
• Cruise on/off switch
• Cruise signal
• Cruise sw
• Fuse 10 10a
• Fuse 2 10a
• Fuse 20 10a
• Fuse 30 10a
• Fuse block (under left side of dash)
• G104 (left rear of engine compt)
• G131 (on intake manifold)
• G201 (behind right sideof dash)
• G202 (behind left side of dash)
• Ground
• Hot at all times
• Hot in on or start
• Ign
• Motor
• Motor 1
• Motor 2
• Motor 3
• Od cancel
• Park/neutral position relay (w/a/t) (in relay box)
• Park/neutral position switch (on left side of transaxle)
• Powertrain control module (pcm) (right rear of engine compt)
• Red
• Set
• Set lamp out
• Set/ coast switch
• Spiral cable
• Starting/ charging system
• Stoplight switch (on brake pedal bracket)
• Transmission control module (tcm) (behind right side of dash)
• Vehicle speed
• Vehicle speed sensor (on transaxle)
• W/ 1.8l
• W/ 2.0l
• W/a/t
• W/m/t