CRUISE CONTROL – Pontiac Aztek Rally 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

3.4L VIN E

3.4L VIN E, Cruise Control Wiring Diagram for Pontiac Aztek Rally 2004

List of elements for 3.4L VIN E, Cruise Control Wiring Diagram for Pontiac Aztek Rally 2004:

• All times
• Brake signal input
• Buick
• Center console fuse block (in floor console)
• Computer data lines system
• Cruise control module (at left side of engine compartment, near strut tower)
• Cruise control release switch (on brake pedal support)
• Cruise fuse 10a
• Cruise indicator (buick)
• Cruise release
• Disable input
• Disable output
• E11
• Engaged input
• Engaged output
• F11
• G111 (engine compartment, on bellhousing, left of starter)
• Ground
• Hot at
• Hot in run or start
• Hzdfl fuse 15a
• Ign
• Ignition
• Instrument cluster system
• Instrument panel cluster (ipc)
• Ipc class 2 serial data
• Logic
• Off
• On/off input
• Pnk
• Powertrain control module (pcm) (at left side of engine compartment, in air cleaner assembly)
• R/a
• Resume/accel input
• S209 (i/p harness, left side of dash, 7.5 cm from p101)
• Serial data
• Set sw
• Set/coast input
• Stoplight switch (on brake pedal support)
• Turn signal switch/ multifunction switch (in steering column)
• Underhood fuse block (front of right wheelhouse, above battery)
• Vehicle speed input
• Vehicle speed sensor (on transaxle)
• Vss high
• Vss low
• Vss output