CRUISE CONTROL – Pontiac G8 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Pontiac G8 2008

List of elements for Cruise Control Wiring Diagram for Pontiac G8 2008:

• 3.6l
• 5 volt ref
• 6.0l
• Accelerator pedal position (app) sensor under left side of dash
• App sens 1 sig
• App sens 2 sig
• Automatic transmission
• Automatic transmission (6 speed a/t)
• Automatic transmission shift lever
• Batt
• Batt pos volt
• Bcm fuse 9 10a
• Body control module (bcm) (under left side of dash, right of steering column)
• Brake pedal position (bpp) sensor (top of brake pedal assembly)
• Computer data lines system
• Control solenoid valve assembly
• Cruise ctrl sw sig
• Cruise ind
• Data bus +
• Data bus -
• Driver information center
• Ecm batt fuse 10 15a
• Engine control module (ecm) (right side of engine compt)
• Hot at all times
• Input speed sensors (oss)
• Inst/disp/ rfa/dlc fuse 5 10a
• Instrument panel cluster (ipc)
• Instrument panel fuse block (behind left kick panel)
• J143 (in automatic transmission harness)
• J218 (in instrument panel harness)
• J221
• Lo spd ser data
• Logic
• Low ref
• On/off
• Output speed sensors (oss)
• Rear fuse block (right side of rear compt)
• Red
• Red b
• Res +
• Set -
• Sply volt
• Stop lp sw sig
• Tac mtr ctrl 1
• Tac mtr ctrl 2
• Throttle body (center front of engine)
• Tp sens 1 sig
• Tp sens 2 sig
• Transmission control module (tcm)
• Transmission control module (tcm) (5 speed a/t) (right rear of engine compt)
• Turn/signal multi- function switch
• Vss high sig
• Vss low sig