CRUISE CONTROL
Cruise Control Wiring Diagram for Toyota Sienna XLE 2001
List of elements for Cruise Control Wiring Diagram for Toyota Sienna XLE 2001:
- (w/ vsc)
- (w/o vsc)
- A13
- Abs & traction ecu (translate ecu) (behind upper left end of dash)
- B10
- B14
- B18
- C10
- C22
- Cancel
- Ccs
- Cig fuse 15a
- Combination meter
- Combination switch
- Cruise
- Cruise control actuator (on left side of engine compartment)
- Cruise control ecu (behind upper left center of dash)
- Cruise control indicator
- Cruise control switch
- D position switch (park/neutral position switch) (on transaxle)
- D13
- Data link connector 1 (on right rear of engine compt)
- Data link connector 3 (below dash, right of steering column)
- Diode (park/neutral position switch) (behind upper left center of dash)
- Driver side j/b 1 (behind dash, left of steering column)
- E10
- Ect
- Ecu-ig fuse 15a
- Electronically controlled transmission solenoid (on left side of transaxle)
- Engine control module (behind right side of dash)
- G202 (left side of dash)
- G206 (right instrument panel brace)
- Gauge fuse 10a
- Gnd
- Hot at all times
- Hot in acc or on
- Hot in on or start
- I2 (dash harn, behind left side of dash)
- Idl
- Idlo
- J/b 3 (behind instrument cluster)
- J/c 13 (behind lower right side of dash)
- J/c 17 (behind upper right side of dash)
- J/c 18 (on underside of steering column)
- Od1
- Pnk
- Resume/ accel
- Set/ coast
- Spd
- Stop fuse 15a
- Stoplight switch (on bracket, above brake pedal)
- Stp