Dodge Colt 1994 - FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers 1993-95 Chrysler Motors
Dodge Colt 1994 - IDENTIFICATION FUSE PANEL IDENTIFICATION (1993-95 MODELS)
Fuse panel is located under instrument panel on driver's side of vehicle. Fusible link wires are used to protect a number of circuits. These links will melt in the event of excessive current flow. Replace after determining cause.
Fig. 1: Dodge Colt 1994 - Component Locations - Fuse Panel Identification (1993-95 Models)
Dodge Colt 1994 - FUSE & CIRCUIT BREAKER IDENTIFICATION 1 - 10 Amp
Dome Light.
Dodge Colt 1994 - 2 - 10 Amp
Heater Relay.
Dodge Colt 1994 - 3 - 10 Amp
4 A/T.
Dodge Colt 1994 - 4 - 15 Amp
Stoplights.
Dodge Colt 1994 - 5 - 10 Amp
Turn Signals.
Dodge Colt 1994 - 6 - 20 Amp
Door Locks.
Dodge Colt 1994 - 7 - 10 Amp
Horn.
Dodge Colt 1994 - 8 - 20 Amp
Wiper.
Dodge Colt 1994 - 9 - 25 Amp
Heater.
Dodge Colt 1994 - 10 - 10 Amp
Backup Lights.
Dodge Colt 1994 - 11 - 10 Amp
Meters.
Dodge Colt 1994 - 12 - 15 Amp
Cigarette Lighter.
Dodge Colt 1994 - 13 - 10 Amp
Radio.
Dodge Colt 1994 - 14 - Spare Fuse
Not Used.
Dodge Colt 1994 - CAUTIONS & WARNINGS BATTERY
WARNING: When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See the COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.
Dodge Colt 1994 - SUPPLEMENTAL RESTRAINT (AIR BAG SYSTEM) (IF EQUIPPED)
WARNING: The Diagnostic Energy Reserve Module (DERM) can maintain enough voltage to cause a deployment of the Inflator Module for up to 10 minutes after the Ignition Switch is turned off and the battery is disconnected. Many of the service procedures require disconnection of the Inflator Module to avoid an accidental deployment.