ELECTRONIC POWER STEERING – GMC Sierra Classic 2500 HD 2007 – SYSTEM WIRING DIAGRAMS

ELECTRONIC POWER STEERING

Electronic Power Steering Wiring Diagram, Hybrid for GMC Sierra Classic 2500 HD 2007

List of elements for Electronic Power Steering Wiring Diagram, Hybrid for GMC Sierra Classic 2500 HD 2007:

• (below steering column) body control module
• (front of right cylinder head)
• (left front of engine)
• (near left kick panel)
• 5v ref
• Anti-theft system
• B11 c2
• B7 c2
• B7 c3
• Battery 3
• Brake pedal position sensor
• Brake pedal position sig
• C1 c4
• C341
• Computer data lines system
• Cruise fuse 10a
• Ehps fuse 125a
• Ehps interlock loop signal
• Ehps-1 fuse 10a
• Electro hydraulic power steering (ehps) module (left front of engine)
• Energy storage box (under rear passenger seat)
• G103 (on right rear of engine block)
• G121
• G122
• G203 (near left "a" pillar)
• G203 (near left 'a" pillar)
• Gnd
• Ground
• Hi speed gmlan ser data bus +
• Hi speed gmlan ser data bus -
• Hot in accy, run & start
• Hot in run
• Hot in run & start
• I/p fuse block (on lower left side of dash)
• I/p relay block
• Ign 0 voltage
• Ign voltage
• Info not avail
• Info not available
• Ing 0 fuse 10a
• Interior lights system
• Low ref
• Nca
• Pnk
• Red
• S103
• S120
• S121
• S131
• S216
• S240
• Service dis- connect
• Starting/ charging system
• Steering wheel position master pulse signal
• Steering wheel position sensor signal
• Steering wheel position signal a
• Steering wheel position signal b
• Steering wheel speed/position sensor (on steering column)
• Tan
• Underhood secondary fuse block (left side of eng compt, rear of battery)