ELECTRONIC SUSPENSION – Chevrolet Corvette Z06 2009 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Chevrolet Corvette Z06 2009

List of elements for Electronic Suspension Wiring Diagram for Chevrolet Corvette Z06 2009:

• Abs/ mrrtd fuse 3 10a
• Battery positive volt
• Body control module (bcm) (mounted on toe board, in right footwell)
• Computer
• Computer data lines system
• Ctrl sw sig
• Data (+)
• Data (-) x2
• Data lines system
• Driver information center (dic) display
• E11
• Electronic suspension control (esc) module (behind the right front fender, above ecm)
• G402 (at rear of vehicle, on inner side of right frame rail)
• Ground
• Hot at all times
• Hot w/ run/crnk relay energized
• Ignition voltage
• Instrument panel cluster (ipc)
• Interior lights system
• J139
• J246
• J420
• Left front shock absorber actuator (left front shock absorber)
• Left front suspension position sensor (left front suspension shock absorber)
• Left rear shock absorber actuator (left rear shock absorber)
• Left rear suspension position sensor (left rear suspension control arm)
• Lf damper control
• Lf position sens sig
• Lf voltage reference
• Logic
• Low reference
• Lr damper control
• Lr position sens sig
• Lr voltage reference
• Mrrtd fuse 13 25a
• Nca
• Pnk
• Rf damper control
• Rf position sens sig
• Rf voltage reference
• Right front shock absorber actuator (right front shock absorber)
• Right front suspension position sensor (right front suspension shock absorber)
• Right rear shock absorber actuator (right rear shock absorber)
• Right rear suspension position sensor (right rear suspension control arm)
• Rr damper control
• Rr position sens sig
• Rr voltage reference
• Serial data bus (+)
• Serial data bus (-)
• Suspension control switch
• Tan
• Underhood fuse block (on right side of engine compt)