ELECTRONIC SUSPENSION
Electronic Suspension Wiring Diagram for Ford Crown Victoria Police Interceptor 2010
List of elements for Electronic Suspension Wiring Diagram for Ford Crown Victoria Police Interceptor 2010:
- (body main wiring harness, near breakout to c423) s450
- (dash panel to headlight junction harness, near breakout to battery junction box)
- (dash panel to headlight junction harness, near breakout to powertrain control module) s113
- (right side of engine compt) battery junction box (bjb)
- (under rear of vehicle, attached to control arm) air suspension height sensor
- Air suspension compressor assembly (left front side of engine compt)
- Air suspension compressor relay
- Air suspension disable switch (left side of luggage compt)
- Backht a
- Batt
- Battery junction box (bjb) (right side of engine compt)
- C2131a
- C2131b
- Central junction box (cjb) (under left side of dash)
- Compressor
- Computer data lines system
- Fuse 10a
- Fusible link 112 30a
- G102 (front of left fender)
- G109 (front of right fender)
- G405 (behind center of rear seat)
- Gnd
- Hot at all times
- Hot in run
- Hs can+
- Hs can-
- Ht sens pwr
- Left rear air spring solenoid valve (under left rear of vehicle)
- Lh sol
- Nca
- On/off sw
- Pnk
- Return
- Rh sol
- Right rear air spring solenoid valve (under right rear of vehicle)
- S112 (dash panel to headlight junction harness, near breakout to c1010)
- S121
- S490 (main body wiring harness, near breakout to fuel pump driver module)
- Sw ign
- Vehicle dynamics module (vdm)
- Vent
- Vpwr