GROUND DISTRIBUTION – Nissan 240SX SE 1994 – SYSTEM WIRING DIAGRAMS

GROUND DISTRIBUTION

Ground Distribution Wiring Diagram (1 of 3) for Nissan 240SX SE 1994

List of elements for Ground Distribution Wiring Diagram (1 of 3) for Nissan 240SX SE 1994:

• A/t
• Accessory relay no. 2
• Alternator
• Ascd control unit
• Ascd hold relay
• Brake fluid level switch
• Clutch interlock switch
• Crank shaft position sensor
• Crank- shaft position shield
• Data link connector
• Daytime light control unit
• Eccs control module (ecm)
• Front wiper amplifier
• Front wiper/ washer switch
• G100 (left front fender)
• G101 (right front fender)
• G103 (right side shock tower)
• G115 (rear of engine)
• G120 (right side of engine)
• Hicas oil level switch
• Hicas solenoid valve
• Iacv- air regulator
• Ignition coil
• Inhibitor relay
• Knock sensor shield
• Left daytime light
• Left front combination lamp (turn, clearance)
• Left front side marker lamp
• Left headlamp motor
• M/t
• Mass air flow sensor shield
• Nca
• Neutral position switch
• Oxygen sensor shield
• Power steering oil level switch
• Power transistor
• Power transistor shield
• Resistor and condenser
• Retract relay no. 1
• Retract relay no. 2
• Retract relay no. 3
• Retract relay no. 4
• Right daytime light
• Right front combination lamp (turn, clearance)
• Right front side marker lamp
• Right headlamp motor
• Throttle position sensor shield
• Washer fluid level switch
• Wiper motor

Ground Distribution Wiring Diagram (2 of 3) for Nissan 240SX SE 1994

List of elements for Ground Distribution Wiring Diagram (2 of 3) for Nissan 240SX SE 1994:

• (top of engine) fuel injectors
• A/f sens 1 htr
• A/f sensor 1
• Can h
• Can l
• Combintion meter
• Computer data lines system
• E21 (left front of engine compt)
• E7 f121
• Engine control module (ecm) (left side of engine compt)
• Engine coolant temp sens
• Engine coolant temperature sensor (rear of engine)
• Evap canister purge volume control solenoid valve (right front of engine)
• F121
• F123
• Fuel inj 1
• Fuel inj 2
• Fuel inj 3
• Fuel inj 4
• Fuel pump rly
• Gnd
• Heated oxygen sens 2
• Heated oxygen sens 2 htr
• Ign sig 1
• Ign sig 2
• Ign sig 3
• Ign sig 4
• Intake air temp sens
• Mal function indicator lamp
• Pnk
• Red
• Refrigerant pressure sens
• Refrigerant pressure sensor (left front of engine compt)
• Relay (self shut-off) evap canster purge vol ctrl solenoid valve
• Sens power sply
• Sensor gnd
• Throttle ctrl mtr (close)
• Throttle ctrl mtr (open)
• Throttle ctrl mtr rly
• Throttle ctrl mtr rly pwr sply
• Throttle position sens 1
• Throttle position sens 2

Ground Distribution Wiring Diagram (3 of 3) for Nissan 240SX SE 1994

List of elements for Ground Distribution Wiring Diagram (3 of 3) for Nissan 240SX SE 1994:

• Ashtray illumination
• Auto antenna timer
• Cigarette lighter
• Data link connector
• Door mirror switch
• Fuel pump
• Fuel tank gauge unit
• G300 (below left front seat)
• G407 (center rear of trunk)
• G908 (center front of roof)
• Hicas control switch
• Hicas control unit
• Hicas fail safe solenoid valve
• High mount stop lamp
• Left lap buckle switch
• Left license lamp
• Left rear combination lamp (stop, tail, back up)
• Left rear side marker lamp
• Left side automatic seat belt motor assembly
• Left side door switch
• M/t
• Overdrive control switch
• Rear limit switch
• Rear wiper amplifier
• Rear wiper motor
• Right license lamp
• Right rear combination lamp (stop, tail, back up)
• Right rear side marker lamp
• Right side automatic seat belt motor assembly
• Shoulder belt buckle switch
• Slide relay (close)
• Slide relay (open)
• Sun roof limit switch
• Trunk room lamp switch