INSTRUMENT CLUSTER – Chevrolet Captiva Sport LTZ 2013 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram (1 of 2) for Chevrolet Captiva Sport LTZ 2013

List of elements for Instrument Cluster Wiring Diagram (1 of 2) for Chevrolet Captiva Sport LTZ 2013:

• (under left side of luggage compt) g401
• 4wd ind
• Abs ind
• Air bag ind
• Belt ind pass seat
• Brake fluid level switch (on master brake cylinder reservoir)
• Brake ind
• Charge ind
• Cluster fuse 10a
• Computer data lines system
• Cruise ind
• Data com
• Door ajar ind
• Driver information center (dic) display
• Eco ind
• Electronic compass module (right rear headliner)
• Engine check ind
• Engine coolant temperature ind
• Esc ind
• Esc off ind
• Front fog lamps ind
• Fuel gauge
• G201
• G401 (under left side of luggage compt)
• Gnd
• Ground
• Ground distribution system
• High beam ind
• Hot at all times
• Hot w/ ignition main relay energized
• Ign
• Ign 1 volt
• Illumination
• Instrument panel cluster (ipc)
• Instrument panel fuse block
• Interior lights system
• Ipc fuse 10a
• Isrvm/ rcm fuse 10a
• J370
• Jx201 (right kick panel)
• Left turn ind
• Level sens brake fluid
• Liftgate release & open ind
• Linear interconnect network bus 1
• Logic
• Low ref
• Low tire pressure ind
• Low washer fluid ind
• Off ind ctrl pass air bag
• Oil level ind
• Oil pressure ind
• On ind ctrl pass air bag
• Park brake control switch (base of park brake lever)
• Park brake ind
• Parking brake control module (in front of left rear wheel on frame)
• Pnk
• Release sw sig
• Right turn ind
• Seat belt ind
• Security ind
• Select menu sw sig drv info center
• Serial data lo spd gmlan
• Service engine oil ind
• Service vehicle soon ind
• Speedometer
• Sply volt
• Sw sig drv info center
• Sw signal
• Tachometer
• Underhood fuse block (left side of engine compt)
• Vol ref
• Washer sig windshield
• Wiper/washer system
• X200
• X400
• X405

Instrument Cluster Wiring Diagram (2 of 2) for Chevrolet Captiva Sport LTZ 2013

List of elements for Instrument Cluster Wiring Diagram (2 of 2) for Chevrolet Captiva Sport LTZ 2013:

• 2.4l
• 3.0l
• Bcm fuse 10a
• Body control module (bcm) (front of center floor console)
• Computer data lines system
• Custom- isation
• Driver door latch assembly
• Driver information center (dic) switch
• Engine control module (ecm) (2.4l: left rear of engine compt) (except 2.4l: left front engine compt)
• Engine controls system
• Engine oil pressure (eop) switch (above starter)
• Engine oil pressure (eop) switch (on oil pump housing, on lower right front of engine)
• Eop sw sig
• Fuel level sig
• Fuel pump & level sensor assembly
• G110 (left front frame)
• G201
• G301 (under driver's seat)
• G401 (under left side of luggage compt)
• G402 (right rear trim panel)
• Ground distribution system
• Hi gmlan serial data +
• Hi gmlan serial data -
• Hot at all times
• Interior lights system
• J111
• J345
• J401
• J402
• J506
• J600
• J702
• J802
• J901
• Jx201 (right kick panel)
• Left rear door latch assembly
• Lf door ajar sw
• Liftgate ajar sw
• Liftgate ajar switch s14
• Liftgate latch assembly
• Lo gmlan serial data
• Logic
• Low ref
• Mil ctrl
• Passenger door latch assembly
• Pnk
• Primary fuel level sensor
• Rear wiper motor module
• Rf door ajar sw
• Right rear door latch assembly
• Secondary fuel level sensor (left side of fuel tank)
• Set/ reset
• Tan
• Underhood fuse block (left side of engine compt)
• Vehicle infor- mation
• X108
• X403
• X420
• X422
• X500
• X600
• X700
• X800